Influence of TiO surface defects on the adsorption of N719 dye molecules

• Published in: Physical chemistry chemical physics : PCCP Vol. 23; no. 38; pp. 2216 - 22173
• Main Authors: Shamsaldeen, Altaf A, Kloo, Lars, Yin, Yanting, Gibson, Christopher, Adhikari, Sunita Gautam, Andersson, Gunther G
• Format: Journal Article
• Published: 06.10.2021
• ISSN: 1463-9076; 1463-9084
• DOI: 10.1039/d1cp02283k

Surface defects influence the dye adsorption on TiO 2 used as a substrate in dye-sensitized solar cells (DSSCs). In this study, we have used different Ar + sputtering doses to create a controlled density of defects on a TiO 2 surface exposed to different pre-heating temperatures in order to analyse the influence of defects on the N719 dye adsorption. TiO 2 was pre-treated using two different treatments. The first treatment involved heating to 200 °C with subsequent sputtering at different doses. The second treatment included heating only, but at four different temperatures starting at 200 °C. After the pre-treatments, the TiO 2 samples were immersed into an N719 dye solution for 24 hours at room temperature to dye the TiO 2 substrates. The amount of Ti 3+ surface defects introduced by the different pre-treatments and their influence on dye adsorption onto the TiO 2 surface were examined by X-ray photoelectron spectroscopy (XPS), ultraviolet photoelectron spectroscopy (UPS) and metastable induced electron spectroscopy (MIES). Neutral impact collision ion scattering spectroscopy (NICISS) was used to determine the coverage of the TiO 2 surface by adsorbed dye molecules. It was found that Ti 3+ surface defects were formed by Ar + sputtering but not by pre-treatment through heating alone. MIES analysis of the outer-most layer and density of states calculations show that the thiocyanate ligand of the N719 dye becomes directed away from the TiO 2 surface. Both XPS and NICISS results indicate that the amount of adsorbed N719 dye decreases with increasing density of Ti 3+ surface defects. Thus, the generation of surface defects reduces the ability of the TiO 2 surface to adsorb the dye molecules. Heating alone as pre-treatment of the TiO 2 substrates instead increases the dye adsorption, without causing detectable defects on the TiO 2 surface. Surface defects influence the dye adsorption on TiO 2 used as a substrate in dye-sensitized solar cells (DSSCs).