Ferrous bisglycinate content and release in W(1)/O/W(2) multiple emulsions stabilized by protein- polysaccharide complexes

• Published in: Food hydrocolloids Vol. 23; no. 8; pp. 2425 - 2433
• Main Authors: Jimenez-Alvarado, R, Beristain, C I, Medina-Torres, L, Roman-Guerrero, A, Vernon-Carter, E J
• Format: Journal Article
• Language: English
• Published: 01.12.2009
• ISSN: 0268-005X
• DOI: 10.1016/j.foodhyd.2009.06.022

Ferrous bisglycinate aqueous solution was entrapped in the inner phase (W(1)) of water-in-oil-in-water (W(1)/O/W(2)) multiple emulsions. The primary ferrous bisglycinate aqueous solution-in-mineral oil (W(1)/O) emulsion contained 15% (w/w) ferrous bisglycinate, had a dispersed phase mass fraction of 0.5, and was stabilized with a mixture of Grindsted PGPR 90:Panodan SDK (6:4 ratio) with a total emulsifiers concentration of 5% (w/w). This primary emulsion was re-emulsified in order to prepare W(1)/O/W(2) multiple emulsions, with a dispersed mass fraction of 0.2, and stabilized using protein (whey protein concentrate (WPC)):polysaccharide (gum arabic (GA) or mesquite gum (MG) or low methoxyl pectin (LMP)) complexes (2:1 ratio) in the W(2) aqueous phase. The W(1)/O/W(2) multiple emulsion stabilized with WPC:MG (5% w/w total biopolymers concentration) provided smaller droplet sizes (2.05 km), lower rate of droplet coalescence (7.09 x 10(-7) s(-1)), better protection against ferrous bisglycinate oxidation (29.75% Fe(3+)) and slower rate of ferrous bisglycinate release from W(1) to W(2) (K(H) = 0.69 mg mL(-1) min(-0.5) in the first 24 h and 0.07 mg mL(-1) min(-0.5) for the next 19 days of storage time). Better encapsulation efficiencies, enhanced protection against oxidation and slower release rates of ferrous bisglycinate were achieved as the molecular weight of the polysaccharide making up protein:polysaccharide complex was higher. Thus, the factor that probably affected most the overall functionality of multiple emulsions was the thickness of the complex adsorbed around the multiple emulsion oil droplets. These thicknesses determined indirectly by measuring the z-average diameter of the complexes, and that of the WPC:MG (529.4 nm) was the largest.