Computed tomographic analysis of maxillary sinus anatomy relevant to sinus lift procedures in edentulous ridges in Taiwanese patients

• Published in: Journal of periodontal & implant science Vol. 49; no. 4; pp. 237 - 247
• Main Authors: Yu, Shun-Jen, Lee, Yi-Hao, Lin, Ching-Ping, Wu, Aaron Yu-Jen
• Format: Journal Article
• Language: Korean
• Published: 2019
• Subjects: Sinus floor augmentation; Edentulous jaw; Maxillary sinus; Cone-beam computed tomography; Asians
• ISSN: 2093-2278; 2093-2286

Purpose: To analyze the maxillary sinus anatomy over edentulous ridges in the bilateral posterior maxillary area in Taiwanese patients using cone-beam computed tomography (CBCT). Methods: In total, 101 anatomical sites from 61 patients, including 32 premolar and 69 molar regions, were analyzed using CBCT. Measurements were made of the width and height of edentulous ridges, the thickness of the lateral wall of the maxillary sinus, and the presence of a sinus septum and the posterior superior alveolar artery (PSAA). A statistical analysis of the measurements was performed, and correlations among the measurements were assessed. Results: The average ridge width was $10.26{\pm}3.16mm$, with a significantly greater ridge width in the second molar region than in the premolar region. The mean residual ridge height was $8.55{\pm}4.09mm$, and ridge height showed an opposite trend from ridge width for the premolar and molar regions. A sinus septum was present at 5.9% of the sites, and the PSAA was observed in 24.5%. The average thickness of the lateral wall of the maxillary sinus was $2.08{\pm}0.94mm$, with no significant difference between the tooth position and lateral wall thickness. Conclusions: This study presents the anatomical features of the maxillary sinus, which should be considered in sinus lift procedures for implant placement, in the Taiwanese population. The use of CBCT is recommended to avoid intraoperative complications.