CHARACTERISTICS OF THE PNEUMATIC TRANSFER SYSTEM AND THE IRRADIATION HOLE AT THE HANARO RESEARCH REACTOR

• Published in: Nuclear engineering and technology Vol. 38; no. 6; pp. 585 - 590
• Main Authors: Chung, Yong-Sam, Kim, Sun-Ha, Moon, Jong-Hwa, Kim, Hark-Rho, Kim, Young-Jin
• Format: Journal Article
• Language: Korean
• Published: 2006
• Subjects: Neutron Activation Analysis; Cadmium Ratio; Pneumatic Transfer System; Neutron Irradiation Parameter; Irradiation Rabbit; HANARO Research Reactor; Neutron Flux
• ISSN: 1738-5733; 2234-358X

This paper describes the results of an irradiation test and the specifications of the pneumatic transfer system (PTS) in the NAA #3 irradiation hole at the HANARO research reactor, which was reinstalled after some modifications of the operation mode at the end of 2004. The outer and inner diameters of the PE transfer tube are 34.1 and 27.5 mm, respectively. PE rabbit was used for sample irradiation. The $N_2$ gas pressure of the PTS lines was adjusted to 0.75 bar. The average sending time to the reactor was $8.5{\pm}0.3$ s and the average receiving time back to the receiver was $3.2{\pm}0.2$ s. The internal and external temperature of the irradiation tube was measured in a range of 50 to $80^{\circ}C$ for a 40 s to 80 s irradiation time, respectively. The optimum irradiation time was estimated to be less than 80 s. The thermal, epithermal and fast neutron flux at 30 MW thermal power were $1.42{\pm}0.01{\times}10^{14},\;1.51{\pm}0.04{\times}10^{13}$ and $9.48{\pm}0.69{\times}10^{11} n{\cdot}cm^{-2}{\codt}s^{1-}$, respectively. The cadmium ratio was approximately 9.40. The data obtained will be applied to supplement user information and for reactor management.