Device Simulation of Highly Stable and 29% Efficient FA[sub.0.75]MA[sub.0.25]Sn[sub.0.95]Ge[sub.0.05]I[sub.3]-Based Perovskite Solar Cell

• Published in: Nanomaterials (Basel, Switzerland) Vol. 13; no. 9
• Main Authors: Sabbah, Hussein, Baki, Zaher Abdel
• Format: Journal Article
• Language: English
• Published: MDPI AG 01.05.2023
• Subjects: Analysis; Computer simulation; Computer-generated environments; Electric properties; Mechanical properties; Methods; Perovskite; Solar batteries; Solar cells; Structure; Kuwait
• ISSN: 2079-4991; 2079-4991
• DOI: 10.3390/nano13091537

A new type of perovskite solar cell based on mixed tin and germanium has the potential to achieve good power conversion efficiency and extreme air stability. However, improving its efficiency is crucial for practical application in solar cells. This paper presents a quantitative analysis of lead-free FA[sub.0.75] MA[sub.0.25] Sn[sub.0.95] Ge[sub.0.05] I[sub.3] using a solar cell capacitance simulator to optimize its structure. Various electron transport layer materials were thoroughly investigated to enhance efficiency. The study considered the impact of energy level alignment between the absorber and electron transport layer interface, thickness and doping concentration of the electron transport layer, thickness and defect density of the absorber, and the rear metal work function. The optimized structures included poly (3,4-ethylenedioxythiophene)polystyrene sulfonate (PEDOT:PSS) as the hole transport layer and either zinc oxide (ZnO) or zinc magnesium oxide (Zn[sub.0.7] Mg[sub.0.3] O) as the electron transport layer. The power conversion efficiency obtained was 29%, which was over three times higher than the initial structure. Performing numerical simulations on FA[sub.0.75] MA[sub.0.25] Sn[sub.0.95] Ge[sub.0.05] I[sub.3] can significantly enhance the likelihood of its commercialization. The optimized values resulting from the conducted parametric study are as follows: a short-circuit current density of 30.13 mA·cm[sup.−2] ), an open-circuit voltage of 1.08 V, a fill factor of 86.56%, and a power conversion efficiency of 28.31% for the intended solar cell.