Quick tire unit of moulding plastics

• Main Author: DING MINGBO
• Format: Patent
• Language: Chinese; English
• Published: 04.01.2019
• Subjects: AFTER-TREATMENT OF THE SHAPED PRODUCTS, e.g. REPAIRING; INDEXING SCHEME ASSOCIATED WITH SUBCLASS B29C, RELATING TO PARTICULARARTICLES; PERFORMING OPERATIONS; SHAPING OF MATERIAL IN A PLASTIC STATE, NOT OTHERWISE PROVIDEDFOR; SHAPING OR JOINING OF PLASTICS; TRANSPORTING; WORKING OF PLASTICS; WORKING OF SUBSTANCES IN A PLASTIC STATE, IN GENERAL

The utility model discloses a quick tire unit of moulding plastics, including the die holder, die holder bottom intermediate position is equipped with the core, the core both sides are equipped with the fixed block with die holder matched with, die holder bottom both sides all are equipped with the guide arm respectively, the die holder top is equipped with the heat insulating board, heat insulating board top both sides all are equipped with rings respectively, heat insulating board top intermediate position is equipped with the position circle, the inside runner that is equipped with of position circle, run through to be equipped with between runner and the core and water, water both sides and be located inside being equipped with of die holder and water the piece, it waters to be equipped with two sets of branchings inside watering the bottom and being located the core, the die holder below is equipped with the fixing base, fixing base top both sides all are equipped with respectively and cut off piece and