Effect of bias magnetic field on transducer efficiency in electromagnetic ultrasonic non-destructive testing of Rock bolt
Non-destructive testing (NDT) of rock bolt anchoring quality is an important part of engineering quality and safety control, electromagnetic ultrasonic NDT is one of the promising detection methods, and improving the efficiency of ultrasonic transducer by optimizing the bias magnetic field is an imp...
Saved in:
Published in | Sensors and actuators. A. Physical. Vol. 375 |
---|---|
Main Authors | , , , , |
Format | Journal Article |
Language | English |
Published |
Elsevier B.V
01.09.2024
|
Subjects | |
Online Access | Get full text |
Cover
Loading…
Summary: | Non-destructive testing (NDT) of rock bolt anchoring quality is an important part of engineering quality and safety control, electromagnetic ultrasonic NDT is one of the promising detection methods, and improving the efficiency of ultrasonic transducer by optimizing the bias magnetic field is an important factor to obtain effective information. In this paper, several factors affecting the bias magnetic field are studied, and the work is divided into simulation and demonstration: COMSOL was used to simulate the electromagnetic ultrasonic transducer(EMAT) in order to analyze the influence of the number of magnetic circuit, the thickness of magnet and the thickness of yoke iron on the bias magnetic field. Then, an experimental platform was built, the magnetic circuit structure of the transducer was set with reference to the simulation results, and several important parameters of the bias magnetic field were determined by analyzing the collected signals. The results show that with the increase of the bias magnetic field magnetic circuit structure from independent to ring form, the magnetic field strength of the rock bolt increases, the magnetic field uniformity becomes better, and the efficiency of the transducer is also improved accordingly. In addition, under the same magnetic circuit condition, increasing the thickness of permanent magnet and yoke iron does not increase the magnetic flux density of the rock bolt axis proportionally, and has a limited effect on the efficiency of the transducer. In practical application, the corresponding structure is selected according to the needs, and the better bias magnetic field structure is selected while meeting the efficiency of the transducer.
[Display omitted]
•Several factors affecting the efficiency of the transducer were simulated by COMSOL.•An experimental platform was set up.•The parameters of magnetic circuit number, permanent magnet and yoke iron thickness were analyzed. |
---|---|
ISSN: | 0924-4247 1873-3069 |
DOI: | 10.1016/j.sna.2024.115532 |