Anodic Formation and Photoelectrochemical Characteristics of Ag(I) Oxide on the Ag–Pd-System Alloys

• Published in: Russian journal of electrochemistry Vol. 60; no. 6; pp. 468 - 477
• Main Authors: Belyanskaya, I. A., Bocharnikova, M. Yu, Grushevskaya, S. N., Kozaderov, O. A., Vvedenskii, A. V., Kannykin, S. V.
• Format: Journal Article
• Language: English
• Published: Moscow Pleiades Publishing 2024; Springer Nature B.V
• Subjects: Alpha rays; Anodizing; Chemical composition; Chemistry; Chemistry and Materials Science; Crystal defects; Crystal structure; Electrochemistry; Electrolysis; Oxidation; Palladium; Parameters; Phase composition; Photoelectric effect; Photoelectric emission; Physical Chemistry; Production methods; Quantum efficiency; Silver base alloys; Silver oxides; chronoamperometry; photopotential; silver oxide; voltammetry; photocurrent; silver–palladium alloys
• ISSN: 1023-1935; 1608-3342
• DOI: 10.1134/S1023193524700046

Silver(I) oxide is considered as one of the promising materials for photoelectrochemical technologies because it has an optimal band gap, relatively low cost, and a wide variety of production methods. However, its characteristics such as quantum efficiency, morphology, and crystal structure parameters require optimization, which can be achieved by applying the most suitable method for the obtaining of the material. One of the fairly simple methods is the anodic oxidation of silver or its alloys in alkaline media, which allows obtaining oxide phases with a controlled composition and predictable properties by varying the concentration of the alloy components and electrolysis mode. The purpose of this work is to reveal the features of anodic formation and to determine the photoelectrochemical characteristics of silver(I) oxide on silver–palladium alloys in deaerated 0.1 M KOH solution. The regularities of the anodic formation of Ag(I) oxide on alloys of the Ag–Pd-system with the palladium atomic fraction from 0.05 to 0.20 in deaerated 0.1 M KOH solution were studied by non-stationary electrochemical methods of cyclic voltammetry, chronoamperometry with synchronous recording of photocurrent, and photopotential measurements. The phase composition of the alloys (alpha phase) was determined from the results of X-ray diffractometry. Chemical composition was determined by energy dispersive microanalysis. Photoelectrochemical parameters were calculated from the results of the photocurrent and photopotential measurements. It was established that the Ag(I) oxide anodically formed on silver–palladium alloys is characterized by n -type conductivity and the predominance of donor defects. On the alloys with a relatively low palladium concentration (5 and 10 at %), Ag(I) oxide with a higher concentration of defects is formed, while on alloys with a relatively high palladium concentration (15 and 20 at %), with a lower concentration of defects than on pure silver.