CO2 and steam electrolysis using a microtubular solid oxide cell

• Published in: JPhys Energy Vol. 2; no. 1
• Main Authors: Monzón, Hernán, Laguna-Bercero, Miguel A
• Format: Journal Article
• Language: English
• Published: Bristol IOP Publishing 01.01.2020
• Subjects: Carbon dioxide; Coated electrodes; coelectrolysis; Dilution; Electrolysis; Electrolytes; Electrolytic cells; Extrusion molding; Gas chromatography; Immersion coating; Lanthanum; Nickel; Shift reaction; SOEC; SOFC; Water gas; Yttria-stabilized zirconia; Yttrium oxide; zirconia; Zirconium dioxide
• ISSN: 2515-7655
• DOI: 10.1088/2515-7655/ab4250

Nickel-yttria stabilized zirconia (Ni-YSZ) supported tubes were fabricated by plastic extrusion molding (PEM). YSZ was used as the electrolyte and LSM-YSZ (lanthanum-strontium doped manganite) as the oxygen electrode. Both layers were deposited by dip coating and were then sintered at 1500 °C and 1150 °C, respectively. Coelectrolysis experiments were performed in these cells at 850 °C, using different fuel gas conditions varying the amount of steam, carbon dioxide, nitrogen and hydrogen. Area specific resistance (ASR) values ranged from 0.47 cm2, when rich steam and CO2 flows are used, to 1.74 cm2, when a diluted composition is used. Gas chromatography was used to examine the amount of H2 and CO in the output gas. The obtained results are consistent with the equilibrium of the water gas shift reaction. For all the different analysed conditions, faradaic efficiency was found to be close to 100%. This experiment confirmed that there is no electronic conduction taking place through the YSZ electrolyte. The threshold for electronic conduction in the diluted feeding conditions (Poor H2O and CO2) for these particular YSZ-based cell was found at voltages of about 1.65 V.