Enhanced efficiency of dye-sensitized solar cells based on Mg and La co-doped TiO2 photoanodes

• Published in: Electrochimica acta Vol. 178; pp. 240 - 248
• Main Authors: Tanyi, Ako Rajour, Rafieh, Alwani Imanah, Ekaneyaka, Piyasiri, Tan, Ai Ling, Young, David James, Zheng, Zhang, Chellappan, Vijila, Subramanian, Gomathy Sandhya, Chandrakanthi, R.L.N.
• Format: Journal Article
• Language: English
• Published: Elsevier Ltd 01.10.2015
• Subjects: charge transfer resistance; co-doped TiO2; DSSC; Mg; charge transfer resistance; La; co-doped TiO2; DSSC
• ISSN: 0013-4686; 1873-3859
• DOI: 10.1016/j.electacta.2015.07.172

[Display omitted] •Mg and La single doped and co-doped TiO2 has been synthesized by a sol gel technique.•DSSC with 0.5mol.% Mg and La co-doped TiO2 anodes achieved 8.0% PCE, a 20% improvement over that of pure TiO2 anodes.•Mg2+ substituted Ti4+ and raised the conduction band while La3+ on crystal lattices increased trap states.•A significant elevation of the free surface energy state has been observed as a result of MgLa co-doping onto TiO2.•Charge recombination at the oxide-dye-electrolyte interface in DSSC is significantly suppressed when doped TiO2 anode was doped with both Mg and La. The efficiency of Dye-Sensitized Solar Cells (DSSC) can be significantly enhanced by optimizing the concentration of surface trap states and by tailoring the band gap energy in the semiconductor oxides used as photoanodes. Magnesium (Mg) and Lanthanum (La) ions have been co-doped onto TiO2 and used for the fabrication of photoanodes for DSSC. The doped TiO2 particles were characterized by SEM, XRF, XRD, Raman, XPS and UV–vis diffuse reflection spectroscopy. The fabricated cells were characterized by I-V and EIS techniques. XRD and Raman measurements performed on the doped powders showed only peaks ascribed to pure anatase. The particle sizes were significantly reduced by doping with the double metal ions, La and Mg, as calculated by the Scherrer equation using the anatase XRD 101 peaks. Current - voltage measurements on the fabricated DSSC presented maximum photoelectric conversion efficiency (PCE) of 8.04% from cells with 0.5mol.% Mg and La co-doped TiO2 anodes (0.5MgLa-TiO2), which gave a 20% improvement over cells with pure TiO2 anodes that had 6.7% PCE. The DSSC performance reduced gradually to 6.67 and 5.45 as the concentration of the co-dopants, Mg and La increased to 1 and 2mol.% respectively. DSSC with 1mol.% Mg doped TiO2 photoanodes (1Mg-TiO2) and 1mol.% La doped TiO2 photoanodes (1La-TiO2) reached 6.8% and 7.6% PCE, respectively, lower than that of 0.5MgLa-TiO2. EIS analysis showed that the DSSC with co-doped TiO2 anodes indicated an overall stronger resistance to charge recombination with the electrolyte than those with the single doped and pure TiO2 photoanodes. 0.5MgLa-TiO2 was found to be the optimum concentration for DSSC efficiency with reduced charge recombination. This is attributed to the elevation of free surface state energy and the presence oxygen vacancy (trap states) as compared to pure TiO2.