Method for Aluminum Oxide Thin Films Prepared through Low Temperature Atomic Layer Deposition for Encapsulating Organic Electroluminescent Devices

• Published in: Materials Vol. 8; no. 2; pp. 600 - 610
• Main Authors: Li, Hui-Ying, Liu, Yun-Fei, Duan, Yu, Yang, Yong-Qiang, Lu, Yi-Nan
• Format: Journal Article
• Language: English
• Published: Switzerland MDPI AG 10.02.2015; MDPI
• Subjects: Aluminum; Aluminum oxide; atomic layer deposition; Deposition; Devices; Encapsulation; Humidity; Industrial development; lower temperature; Methods; Permeability; Pumping; Temperature; Thin films; uniform thin film; Variability; Water vapor; United States > US; uniform thin film; atomic layer deposition; lower temperature
• ISSN: 1996-1944; 1996-1944
• DOI: 10.3390/ma8020600

Preparation of dense alumina (Al₂O₃) thin film through atomic layer deposition (ALD) provides a pathway to achieve the encapsulation of organic light emitting devices (OLED). Unlike traditional ALD which is usually executed at higher reaction n temperatures that may affect the performance of OLED, this application discusses the development on preparation of ALD thin film at a low temperature. One concern of ALD is the suppressing effect of ambient temperature on uniformity of thin film. To mitigate this issue, the pumping time in each reaction cycle was increased during the preparation process, which removed reaction byproducts and inhibited the formation of vacancies. As a result, the obtained thin film had both high uniformity and density properties, which provided an excellent encapsulation performance. The results from microstructure morphology analysis, water vapor transmission rate, and lifetime test showed that the difference in uniformity between thin films prepared at low temperatures, with increased pumping time, and high temperatures was small and there was no obvious influence of increased pumping time on light emitting performance. Meanwhile, the permeability for water vapor of the thin film prepared at a low temperature was found to reach as low as 1.5 × 10 g/(m²·day) under ambient conditions of 25 °C and 60% relative humidity, indicating a potential extension in the lifetime for the OLED.