Anti-Reflective Zeolite Coating for Implantable Bioelectronic Devices

• Published in: Bioengineering (Basel) Vol. 9; no. 8; p. 404
• Main Authors: Oliva, Giuseppe, Bianco, Maria Giovanna, Fiorillo, Antonino S, Pullano, Salvatore A
• Format: Journal Article
• Language: English
• Published: Basel MDPI AG 01.08.2022; MDPI
• Subjects: Acids; anti-reflective coating; Antireflection coatings; Bioelectricity; Bioengineering; Clean energy; Coatings; Deposition; Efficiency; Energy consumption; High temperature; implantable device; Iodine; Light reflection; Light transmission; medical application; Medical equipment; nanoporous material; Photovoltaic cells; Porosity; Porous materials; Properties; Radiation; Refractivity; Silicon; solar cell; Solar cells; Vegetable oils; Zeolites; United States; United States > US; Germany
• ISSN: 2306-5354; 2306-5354
• DOI: 10.3390/bioengineering9080404

Since sunlight is one of the most easily available and clean energy supplies, solar cell development and the improvement of its conversion efficiency represent a highly interesting topic. Superficial light reflection is one of the limiting factors of the photovoltaic cells (PV) efficiency. To this end, interfacial layer with anti-reflective properties reduces this phenomenon, improving the energy potentially available for transduction. Nanoporous materials, because of the correlation between the refractive index and the porosity, allow low reflection, improving light transmission through the coating. In this work, anti-reflective coatings (ARCs) deposited on commercial PV cells, which were fabricated using two different Linde Type A (LTA) zeolites (type 3A and 4A), have been investigated. The proposed technique allows an easier deposition of a zeolite-based mixture, avoiding the use of chemicals and elevated temperature calcination processes. Results using radiation in the range 470–610 nm evidenced substantial enhancement of the fill factor, with maximum achieved values of over 40%. At 590 and 610 nm, which are the most interesting bands for implantable devices, FF is improved, with a maximum of 22% and 10%, respectively. ARCs differences are mostly related to the morphology of the zeolite powder used, which resulted in thicker and rougher coatings using zeolite 3A. The proposed approach allows a simple and reliable deposition technique, which can be of interest for implantable medical devices.