Fracture modes in curved brittle layers subject to concentrated cyclic loading in liquid environments

• Published in: Journal of materials research Vol. 24; no. 3; pp. 1075 - 1081
• Main Authors: Kim, Jae-Won, Thompson, Van P., Dianne Rekow, E., Jung, Yeon-Gil, Zhang, Yu
• Format: Journal Article
• Language: English
• Published: New York, USA Cambridge University Press 01.03.2009; Springer International Publishing
• Subjects: Applied and Technical Physics; Biomaterials; Fatigue; Fracture; Inorganic Chemistry; Layered; Materials Engineering; Materials Science; Nanotechnology; Layered; Fatigue; Fracture; Curved structure; Bilayer
• ISSN: 0884-2914; 2044-5326
• DOI: 10.1557/jmr.2009.0081

Damage response of brittle curved structures subject to cyclic Hertzian indentation was investigated. Specimens were fabricated by bisecting cylindrical quartz glass hollow tubes. The resulting hemicylindrical glass shells were bonded internally and at the edges to polymeric supporting structures and loaded axially in water on the outer circumference with a spherical tungsten carbide indenter. Critical loads and number of cycles to initiate and propagate near-contact cone cracks and far-field flexure radial cracks to failure were recorded. Flat quartz glass plates on polymer substrates were tested as a control group. Our findings showed that cone cracks form at lower loads, and can propagate through the quartz layer to the quartz/polymer interface at lower number of cycles, in the curved specimens relative to their flat counterparts. Flexural radial cracks require a higher load to initiate in the curved specimens relative to flat structures. These radial cracks can propagate rapidly to the margins, the flat edges of the bisecting plane, under cyclic loading at relatively low loads, owing to mechanical fatigue and a greater spatial range of tensile stresses in curved structures.