Preparation and characterization of PES/CA microporous membranes via reverse thermally induced phase separation process

• Published in: Polymer engineering and science Vol. 58; no. 2; pp. 180 - 191
• Main Authors: Liu, Sheng‐Hui, Xu, Zhen‐Liang, Liu, Min, Wei, Yong‐Ming, Guo, Feng
• Format: Journal Article
• Language: English
• Published: Newtown Society of Plastics Engineers, Inc 01.02.2018; Blackwell Publishing Ltd
• Subjects: Cellulose acetate; Chemical properties; Coagulation; Contact angle; Flux; Mechanical properties; Membrane structures; Membranes; Membranes (Technology); Methods; Phase separation; Polyethersulfone; Polyethersulfones; Polymers; Production processes; Rejection rate; Separation (Technology); Thermal properties
• ISSN: 0032-3888; 1548-2634
• DOI: 10.1002/pen.24545

The blend polyethersulfone (PES)/cellulose acetate (CA) flat‐sheet microporous membranes were prepared by reverse thermally induced phase separation (RTIPS) process. The effects of CA content and coagulation bath temperature on membrane structures and properties were investigated in terms of membrane morphology, water contact angle, permeation performance, and mechanical properties. The cloud point results indicated that the cloud point decreased with the increasing content of CA. When the coagulation bath temperature was lower than the cloud point, the membrane formation process underwent nonsolvent induced phase separation (NIPS) process and dense skin layer and finger‐like structure were formed in membranes. These membranes had lower pure water flux and poor mechanical properties. But when the coagulation bath temperature was higher than the cloud point, the membrane formation process underwent RTIPS process. The porous top surface as well as porous cross‐section of the membranes were formed. Therefore, high pure water flux and good mechanical properties were obtained. The contact angles results indicated that the hydrophilicity of the prepared membranes improved obviously with the addition of CA. When the content of CA was 0.5 wt% and the membrane formation temperature was 323K, the PES/CA microporous membrane which was prepared via the RTIPS process displayed a optimal permeability of the pure water flux of 816 L m−2 h−1 and the BSA rejection rate of 49.5%, which showed an increase of 48.9% and 23.6% than that of pure PES membrane, respectively. Moreover, the mechanical strengths of the membranes obtained by RTIPS process were better than those membranes prepared by NIPS process. POLYM. ENG. SCI., 58:180–191, 2018. © 2017 Society of Plastics Engineers