Adsorption of Cu(II) on Araucaria angustifolia wastes: Determination of the optimal conditions by statistic design of experiments

• Published in: Journal of hazardous materials Vol. 140; no. 1; pp. 211 - 220
• Main Authors: Lima, Eder C., Royer, Betina, Vaghetti, Júlio C.P., Brasil, Jorge L., Simon, Nathalia M., dos Santos, Araci A., Pavan, Flavio A., Dias, Silvio L.P., Benvenutti, Edílson V., Silva, Edson Antônio da
• Format: Journal Article
• Language: English
• Published: Amsterdam Elsevier B.V 09.02.2007; Elsevier
• Subjects: Adsorption; Applied sciences; Araucaria; Araucaria angustifolia; Biological and medical sciences; Biosorption; Biotechnology; Chemical engineering; Congo Red; Copper - isolation & purification; Exact sciences and technology; Fundamental and applied biological sciences. Psychology; Hydrogen-Ion Concentration; Industrial Waste - prevention & control; Low-cost adsorbents; Methods. Procedures. Technologies; Models, Chemical; Others; Pinhão wastes loaded with Congo red; Pollution; Research Design; Statistical design of experiments; Various methods and equipments; Araucaria angustifolia; Pinhão wastes loaded with Congo red; Biosorption; Adsorption; Low-cost adsorbents; Statistical design of experiments; Surface analysis; Modeling; Uptake; Composite material; Optimization; Design; Batchwise; Pinhao wastes loaded with Congo red; Experimental design; pH; Aqueous solution; Factorial design
• ISSN: 0304-3894; 1873-3336
• DOI: 10.1016/j.jhazmat.2006.06.073

Wastes of Araucaria angustifolia (named pinhão) natural (PW) and also loaded with Congo red (CRP) were tested as low-cost adsorbents for Cu(II) removal from aqueous solutions. In order to reduce the total number of experiments to achieve the best conditions of the batch adsorption procedure, three sets of statistical designs of experiments were carried-out for each adsorbent. Initially, a full 2 4 factorial design for each adsorbent with two central points (18 experiments) were performed, to optimize the following factors: mass of adsorbent ( m), pH, time of contact ( t) and initial metallic ion concentration (Co). These results indicated that almost all the main factors and its interactions were significant. It was verified for both adsorbents, that a mass of 30.0 mg leaded to higher Cu(II) uptake and that the best pH for Cu(II) adsorption was 5.6. In order to continue the batch adsorption optimization of the systems, a central composite surface analysis design with two factors (Co, t) containing 13 experiments, divided in to four cube points, four axial points and five centre points was carried-out for each adsorbent. By performing these two sets of statistical design of experiments, the best conditions for Cu(II) uptake using pinhão wastes (PW) and pinhão wastes loaded with Congo red (CRP) using batch adsorption system, where: m = 30.0 mg of adsorbent; pH 5.6; t = 2.5 h. After optimizing the batch adsorption system by statistical design of experiments, isotherms for Cu(II) uptake using PW and CRP were performed. These isotherms fitted to the linear Langmuir and Freundlich models.