Adsorption Behavior and Kinetics of 1,4-Dioxane by Carbon Aerogel

• Published in: Toxics (Basel) Vol. 12; no. 2; p. 145
• Main Authors: Lu, Tianyu, Huang, Huihui, Lv, Guifen, Li, Fei, Song, Ren-Jie, Cai, Yuting
• Format: Journal Article
• Language: English
• Published: Switzerland MDPI AG 12.02.2024; MDPI
• Subjects: 1,4-dioxane; Adsorbents; Adsorption; Aerogels; Analysis; Carbon; carbon aerogels; Carbon cycle; Carcinogens; Chemical properties; Chemical reaction, Rate of; Dioxane; Drinking water; Energy consumption; Experiments; Heating; Heating rate; Kinetics; Microporosity; Miscibility; Pollutants; Porosity; Porous materials; Pyrolysis; Scanning electron microscopy; Solvents; sol–gel method; Specific surface; Surface area; Surface chemistry; Surfactants; Temperature; Trichloroethene; Trichloroethylene; Water pollution; Water purification; China; United States > US; Japan; carbon aerogels; adsorption; sol–gel method; trichloroethylene; 1,4-dioxane
• ISSN: 2305-6304; 2305-6304
• DOI: 10.3390/toxics12020145

1,4-dioxane is a potential carcinogen in water and is difficult to deal with due to its robust cycloether bond and complete miscibility with water. To remove 1,4-dioxane in an economically viable and environmentally friendly way, a series of carbon aerogels were synthesized as adsorbents for 1,4-dioxane. The experiment results showed that adsorption performances were closely related to the preparation conditions of carbon aerogels, such as the molar ratio, heating rate, pyrolysis temperature and residence time, which were carefully controlled. Scanning electron microscope analysis revealed the presence of a three-dimensional porous network structure in carbon aerogels. Brunauer-Emmett-Teller analysis results demonstrated an increase in specific surface area (673.89 m /g) and total pore volume after carbonization, with an increase in mesoporous porosity and a decrease in microporosity. When considering each variable individually, the highest specific surface area of prepared carbon aerogels was achieved at a pyrolysis temperature of 800 °C, a holding time of 1 h, and a heating rate of 2 °C/min. Under optimal experimental conditions, the adsorption removal of 1,4-dioxane by carbon aerogels exceeded 95%, following quasi-second-order kinetics and Langmuir isothermal adsorption isotherms, indicating that monolayer adsorption on the surface of carbon aerogels occurred. The maximum adsorption capacity obtained was 67.28 mg/g at a temperature of 318 K, which was attributed to the presence of a large proportion of mesopores and abundant micropores simultaneously in carbon aerogels. Furthermore, with the interference of chlorinated solvents such as trichloroethylene (TCE), the removal efficiency of 1,4-dioxane had no obvious inhibition effect. Regeneration experiments showed that after five continuous cycles, the carbon aerogels still kept a comparable adsorption capacity, which illustrates its potential application in 1,4-dioxane-polluted water purification.