Single-Layer Planar Monopole Antenna-Based Artificial Magnetic Conductor (AMC)

• Published in: International journal of antennas and propagation Vol. 2022; pp. 1 - 9
• Main Authors: Abdulbari, Ali Abdulateef, Abdul Rahim, Sharul Kamal, Abedi, Firas, Soh, Ping Jack, Hashim, Ali, Qays, Rami, Ahmad, Sarosh, Zeain, Mohammed Yousif
• Format: Journal Article
• Language: English
• Published: New York Hindawi 21.07.2022; Hindawi Limited
• Subjects: Antenna design; Antenna gain; Antenna radiation patterns; Antennas; Bandwidths; Circuit design; Conductors; Coplanar waveguides; Design; Frequencies; Frequency ranges; Ground plane; Internet of Things; Monopole antennas; Monopoles; Musical performances; Patch antennas; Radiation; Resonators; Simulation; Spectrum allocation; Substrates; Unit cell
• ISSN: 1687-5869; 1687-5877
• DOI: 10.1155/2022/6724175

In this paper, a coplanar waveguide (CPW)-fed patch antenna is fabricated on a layer of metasurface to increase gain. The antenna is fabrication on Roger substrate with a thickness of 0.25 mm, with the overall dimension of the proposed design being 45 × 30 × 0.25 mm3. The size of the patch antenna is 24 × 14 × 0.25 mm3, and the AMC unit cell is 22 × 22 × 0.25 mm3. This metasurface is designed based on the split-ring resonator unit cells forming an array of the artificial magnetic conductor (AMC). Meanwhile, the antenna operation on 3.5 GHz is enabled by etching a split-ring resonator slot on the ground plane with a small gap to enhance antenna gain and improve impedance bandwidth when integrated with a metasurface. This simulation planer monopole antenna is applied for 5G application. The experimenter test is applied for the antenna performance in terms of return loss, gain, and radiation patterns. The operating frequency range with and without MTM is from 3.41 to 3.68 GHz (270 MHz) and 3.37 to 3.55 GHz (180 MHz), respectively, with gain improvements of about 2.7 dB (without MTM) to 6.0 dB (with MTM) at 3.5 GHz. The maximum improvement of the gain is about 42% when integrated with the AMC. The AMC has solved several issues to overcome the typical limitation in conventional antenna design. A circuit model is also proposed to simplify the estimation of the performance of this antenna at the desired frequency band. The proposed design is simulated by CST microwave studio. Finally, the antenna is fabricated and measured. Result comparison between simulations and measurements indicates a good agreement between them.