Synergistic effects of curing conditions and magnesium oxide addition on the physico-mechanical properties and firing resistivity of Portland cement mortar

• Published in: Construction & building materials Vol. 176; pp. 676 - 689
• Main Authors: Abdel-Gawwad, H.A., Abo El-Enein, S.A., Heikal, Mohamed, Abd El-Aleem, S., Amer, A.A., El-Kattan, I.M.
• Format: Journal Article
• Language: English
• Published: Elsevier Ltd 10.07.2018; Elsevier B.V
• Subjects: Accelerated carbonation; Analysis; Cements (Building materials); Concrete curing; Electric properties; Firing resistivity; Hydration reaction; Mechanical properties; Porosity; Residual strength; Thermal properties; Egypt; Porosity; Hydration reaction; Firing resistivity; Accelerated carbonation; Residual strength
• ISSN: 0950-0618; 1879-0526
• DOI: 10.1016/j.conbuildmat.2018.05.092

•Cement mortars with or without MgOs were cured in different conditions.•Different curing media were used, i.e. Tap water, normal, and accelerated carbonations.•The performance of cement mortar depends on synergistic MgO and curing conditions. An experimental investigation was performed to evaluate the impact of curing conditions on the physico-mechanical properties and firing resistivity of cement mortar (CM) containing reactive magnesium oxide (MgO). Three different curing media including Tap water (TW), normal carbonation (NC) and accelerated carbonation (AC), have been applied. Two MgOs with different reactivity were used (MgO550 and MgO1250); where, 550 and 1250 are referred to the calcination temperatures applied on hydromagnesite. 10 mass % of MgO550 as well as MgO1250 were individually added to CM. The cured CMs were exposed to different elevated temperatures (250, 500 and 750 °C) for 2 h soaking time. The phases composition and microstructure of CMs were investigated via Fourier transform infrared (FTIR) spectroscopy, X-ray diffraction (XRD), thermogravimetric analysis (TGA) and scanning electron microscopy (SEM) techniques. The results proved that the physico-mechanical properties and firing resistivity of control CM without MgOs cured in TW were superior to those exposed to NC and AC. The MgOs have detrimental impact on the properties of TW-cured-CM, due to the formation magnesium silicate hydrate with lower binding capacity compared to calcium silicate hydrate. Interestingly, the CM-MgOs cured in AC or NC showed the highest mechanical properties as well as firing resistivity compared to control sample at the same curing media, respectively. In AC and NC, the MgO1250 has a higher impact on compressive strength development and firing withstanding of CM compared to MgO550. The optimum curing condition and MgO type, which gave the highest engineering properties and the highest resistivity to elevated temperature were AC and MgO1250.