Maximizing the fixation strength of modular components by impaction without tissue damage

• Published in: Bone & joint research Vol. 7; no. 2; pp. 196 - 204
• Main Authors: Krull, A, Morlock, M M, Bishop, N E
• Format: Journal Article
• Language: English
• Published: England British Editorial Society of Bone & Joint Surgery 01.02.2018
• Subjects: Arthroplasty (hip); Corrosion; Energy; Hip; Implant Failure; Joint surgery; Modular Connection; Tissue Damage; Tissue damage; Implant failure; Modular connection
• ISSN: 2046-3758; 2046-3758
• DOI: 10.1302/2046-3758.72.BJR-2017-0078.R2

Taper junctions between modular hip arthroplasty femoral heads and stems fail by wear or corrosion which can be caused by relative motion at their interface. Increasing the assembly force can reduce relative motion and corrosion but may also damage surrounding tissues. The purpose of this study was to determine the effects of increasing the impaction energy and the stiffness of the impactor tool on the stability of the taper junction and on the forces transmitted through the patient's surrounding tissues. A commercially available impaction tool was modified to assemble components in the laboratory using impactor tips with varying stiffness at different applied energy levels. Springs were mounted below the modular components to represent the patient. The pull-off force of the head from the stem was measured to assess stability, and the displacement of the springs was measured to assess the force transmitted to the patient's tissues. The pull-off force of the head increased as the stiffness of the impactor tip increased but without increasing the force transmitted through the springs (patient). Increasing the impaction energy increased the pull-off force but also increased the force transmitted through the springs. To limit wear and corrosion, manufacturers should maximize the stiffness of the impactor tool but without damaging the surface of the head. This strategy will maximize the stability of the head on the stem for a given applied energy, without influencing the force transmitted through the patient's tissues. Current impactor designs already appear to approach this limit. Increasing the applied energy (which is dependent on the mass of the hammer and square of the contact speed) increases the stability of the modular connection but proportionally increases the force transmitted through the patient's tissues, as well as to the surface of the head, and should be restricted to safe levels. : A. Krull, M. M. Morlock, N. E. Bishop. Maximizing the fixation strength of modular components by impaction without tissue damage. 2018;7:196-204. DOI: 10.1302/2046-3758.72.BJR-2017-0078.R2.