Laboratory study of PCB transport from primary sources to settled dust

• Published in: Chemosphere (Oxford) Vol. 149; pp. 62 - 69
• Main Authors: Liu, Xiaoyu, Guo, Zhishi, Krebs, Kenneth A., Greenwell, Dale J., Roache, Nancy F., Stinson, Rayford A., Nardin, Joshua A., Pope, Robert H.
• Format: Journal Article
• Language: English
• Published: England Elsevier Ltd 01.04.2016
• Subjects: Adsorption; Air Pollution, Indoor - analysis; Air Pollution, Indoor - statistics & numerical data; Aluminum; Arizona; Chamber testing; Construction Materials; Dust - analysis; Dust/air partition; Dust/source partition; Environmental Exposure - analysis; Environmental Monitoring; Polychlorinated biphenyls (PCBs); Polychlorinated Biphenyls - analysis; Settled dust; USA, Arizona; Dust/air partition; Dust/source partition; Chamber testing; Polychlorinated biphenyls (PCBs); Settled dust
• ISSN: 0045-6535; 1879-1298
• DOI: 10.1016/j.chemosphere.2016.01.075

Dust is an important sink for indoor air pollutants, such as polychlorinated biphenyls (PCBs) that were used in building materials and products. In this study, two types of dust, house dust and Arizona Test Dust, were tested in a 30-m3 stainless steel chamber with two types of panels. The PCB-containing panels were aluminum sheets coated with a PCB-spiked primer or caulk. The PCB-free panels were coated with the same materials but without PCBs. The dust evenly spread on each panel was collected at different times to determine its PCB content. The data from the PCB panels were used to evaluate the PCB migration from the source to the dust through direct contact, and the data from the PCB-free panels were used to evaluate the sorption of PCBs through the dust/air partition. Settled dust can adsorb PCBs from air. The sorption concentration was dependent on the congener concentration in the air and favored less volatile congeners. When the house dust was in direct contact with the PCB-containing panel, PCBs migrated into the dust at a much faster rate than the PCB transfer rate due to the dust/air partition. The dust/source partition was not significantly affected by the congener's volatility. For a given congener, the ratio between its concentration in the dust and in the source was used to estimate the dust/source partition coefficient. The estimated values ranged from 0.04 to 0.16. These values are indicative of the sink strength of the tested house dust being in the middle or lower-middle range. •Dust/source and dust/air partitions of PCBs were investigated in a 30-m3 chamber.•House dust and Arizona Test Dust on coated panels with/without PCBs were tested.•Settled dust can adsorb PCBs from air.•The house dust tested is a modest sink for PCBs.•PCB's dust/source partition rate is much faster than its dust/air partition rate.