Evaluating rolling shear strength properties of cross-laminated timber by short-span bending tests and modified planar shear tests

• Published in: Journal of wood science Vol. 63; no. 4; pp. 331 - 337
• Main Author: Li, Minghao
• Format: Journal Article
• Language: English
• Published: Tokyo Springer Japan 01.08.2017; Springer Nature B.V
• Subjects: Bend strength; Bend tests; Biomedical and Life Sciences; Characterization and Evaluation of Materials; Cross laminating; Failure mechanisms; Life Sciences; Materials Science; Original Article; Plates (structural members); Properties (attributes); Shear strength; Shear tests; Thickness; Timber (structural); Wood laminates; Wood Science & Technology; Cross-laminated timber; Radiata pine; Rolling shear; Bending tests; Planar shear tests
• ISSN: 1435-0211; 1611-4663
• DOI: 10.1007/s10086-017-1631-6

This paper presents an experimental study on rolling shear (RS) strength properties of non-edge-glued cross-laminated timber (CLT) made out of New Zealand Radiata pine ( Pinus radiata ) structural timber. CLT specimens with 35 and 20 mm thick laminations were studied to evaluate the influence of lamination thickness on the RS strength of CLT. Short-span three-point bending tests were used to introduce high RS stresses in cross layers of CLT specimens and facilitate the RS failure mechanism. Modified planar shear tests from the conventional two-plate planar shear tests were also used to evaluate the RS strength properties. It was found that two test methods yielded comparable RS strength properties and the lamination thickness significantly affected RS strength of the CLT specimens. The test results also indicated that the recommended characteristic RS strength values of CLT products in Europe and Canada might be over conservative. Also, it might be more efficient to specify different RS strength values for CLT with different lamination thickness given the minimum width-to-depth ratio of laminations is satisfied.