Laser Surface Texturing and Electropolishing of CoCr and Ti6Al4V-ELI Alloys for Biomedical Applications

• Published in: Materials Vol. 13; no. 22; p. 5203
• Main Authors: Sandoval-Robles, Jesús A., Rodríguez, Ciro A., García-López, Erika
• Format: Journal Article
• Language: English
• Published: Basel MDPI AG 17.11.2020; MDPI
• Subjects: Acids; Biomedical materials; Chemical analysis; Chemical composition; Chromium; CoCr; Electrolytes; Electropolishing; Intermetallic compounds; Laser beam texturing; laser texturing; Lasers; Molybdenum; Orthopaedic implants; Orthopedics; Oxidation; Parameters; Phase transitions; Prostheses; Software; Surface properties; Surface roughness; Surgical implants; Texturing; Ti6Al4V ELI; Titanium alloys; Titanium base alloys; Topography; Transplants & implants; X ray spectrometers; United States > US; Germany
• ISSN: 1996-1944; 1996-1944
• DOI: 10.3390/ma13225203

The interplay between a prosthetic and tissue represents an important factor for the fixation of orthopedic implants. Laser texturing tests and electropolishing were performed on two materials used in the fabrication of medical devices, i.e., CoCr and Ti6Al4V-ELI alloys. The material surface was textured with a diode-pumped solid state (DPSS) laser and its effect on the surface quality and material modification, under different combinations of laser power and marking speed, were investigated. Our results indicate that an increment of energy per unit length causes an incremental trend in surface roughness parameters. Additionally, phase transformation on the surface of both alloys was achieved. Chemical analysis by energy dispersive X-ray spectrometer (EDX) shows the formation of (Co(Cr,Mo)) phase and the M23C6 precipitate on the CoCr surface; while quantitative analysis of the X-ray diffractometer (XRD) results demonstrates the oxidation of the Ti alloy with the formation of Ti2O and Ti6O from the reduction of the α-Ti phase. The behaviors were both related with an increase of the energy per unit length. Control of the final surface roughness was achieved by an electropolishing post-treatment, minimizing the as-treated values. After polishing, a reduction of surface roughness parameters was obtained in a range between 3% and 44%, while no changes in chemical composition or present phases were observed.