Joining of aluminum alloy to steel by friction stir welding

• Published in: Journal of materials processing technology Vol. 178; no. 1; pp. 342 - 349
• Main Authors: Watanabe, Takehiko, Takayama, Hirofumi, Yanagisawa, Atsushi
• Format: Journal Article
• Language: English
• Published: Elsevier B.V 14.09.2006
• Subjects: Aluminum alloy; Friction stir welding; Joining of dissimilar metals; Steel; Tensile strength of a joint; Joining of dissimilar metals; Tensile strength of a joint; Steel; Friction stir welding; Aluminum alloy
• ISSN: 0924-0136
• DOI: 10.1016/j.jmatprotec.2006.04.117

The authors tried to butt-weld an aluminum alloy plate to a mild steel plate by friction stir welding, and investigated the effects of a pin rotation speed, the position for the pin axis to be inserted on the tensile strength and the microstructure of the joint. The behavior of the oxide film on the faying surface of the steel during welding also was examined. The main results obtained are as follows. Butt-welding of an aluminum alloy plate to a steel plate was easily and successfully achieved by friction stir welding. The maximum tensile strength of the joint was about 86% of that of the aluminum alloy base metal. A small amount of intermetallic compounds was formed at the upper part of the steel/aluminum interface, while no intermetalic compounds were observed in the middle and bottom parts of the interface. The regions where the intermetallic compounds formed seemed to be fracture paths in the joint. Many fragments of the steel were scattered in the aluminum alloy matrix and the oxide film removed from the faying surface of the steel by the rubbing motion of a rotating pin was observed at the interface between the steel fragments and the aluminum alloy matrix.