Experimental study on the influence of coal powders on the performance of water-based polymer drilling fluid

• Published in: Energy exploration & exploitation Vol. 38; no. 5; pp. 1515 - 1534
• Main Authors: Zhang, Lei, Wu, Xiaoming, Lyu, Shuaifeng, Shen, Penglei, Liu, Lulu, Mou, Yongzhong, Sun, Yujie
• Format: Journal Article
• Language: English
• Published: London, England Sage Publications, Ltd 01.09.2020; SAGE Publications; Sage Publications Ltd; SAGE Publishing
• Subjects: Adhesion; Adhesion tests; Anthracite; Coal; Coalbed methane; Contact angle; Degradation; Drilling fluids; Filtration; Lignite; Lubricity; Microfracture; Parameters; Polymers; Research Article; Rheological properties; Rheology; Stress intensity factors; Surface tension; Testing; Water purification; Wettability; Drilling along coal seam; coal powders; polymer drilling fluid; stress intensity factor; reservoir protection
• ISSN: 0144-5987; 2048-4054
• DOI: 10.1177/0144598720949977

Coal powders, as cuttings, invade the drilling fluid along a coal seam during coalbed methane development, thereby changing the properties of the drilling fluid. Therefore, this work aims to investigate the influence of coal powders on drilling fluid performance. The powders of lignite, anthracite, and contrasting shale were added to a water-based polymer drilling fluid. Then, the rheology, filtration, lubricity, and adhesiveness were measured, and the natural degradation, as well as the wettability were further evaluated. The results show that some parameters of the drilling fluid, including viscosity, lubrication coefficient, adhesion coefficient, contact angle, and surface tension, increase after adding coal powders, while other parameters, such as filtration loss and natural degradation, decrease. Compared with lignite and shale, anthracite powders, with the lowest mineral content, exhibit the smallest change in the rheological property, lubricity, adhesion, and natural degradation of the drilling fluid. Moreover, the content and size of the coal powders generally have opposing effects on the drilling fluid. When the coal powder content reaches 3 wt.%, the surface tension and contact angle of the drilling fluid show more evident changes than other parameters. Based on the analysis of the stress intensity factor, the drilling fluid with coal powders exceeding 100 mesh can reduce the capillary force in microfractures, and in combination with other factors (such as reduced filtration loss and sealing and supporting of the microfractures), improves wellbore stability. Therefore, coal powders with suitable particle sizes and concentration levels are expected to become a new drilling fluid material to protect coal field reservoirs.