Analytical relationships for the mechanical properties of additively manufactured porous biomaterials based on octahedral unit cells

• Published in: Applied Mathematical Modelling Vol. 46; pp. 408 - 422
• Main Authors: Hedayati, R., Sadighi, M., Mohammadi-Aghdam, M., Zadpoor, A.A.
• Format: Journal Article
• Language: English
• Published: New York Elsevier Inc 01.06.2017; Elsevier BV
• Subjects: Additive manufacturing; Analytical solution; Beam theory (structures); Biological properties; Biomedical materials; Boundary conditions; Density; Elastic properties; Eulers equations; Finite element; Finite element method; Mathematical models; Mechanical properties; Modulus of elasticity; Numerical analysis; Octahedral; Poisson's ratio; Pore size; Porosity; Porous biomaterials; Porous materials; Struts; Surgical implants; Unit cell; Yield strength; Yield stress; Additive manufacturing; Elastic properties; Octahedral; Analytical solution; Porous biomaterials; Finite element
• ISSN: 0307-904X; 1088-8691; 0307-904X
• DOI: 10.1016/j.apm.2017.01.076

•Analytical relationships were obtained for a new unit cell type, octahedral.•The effect of build orientation is taken into account in the analytical solution.•The results are supported by experimental tests and numerical results. Additively manufacturing (AM) techniques make it possible to fabricate open-cell interconnected structures with precisely controllable micro-architectures. It has been shown that the morphology, pore size, and relative density of a porous structure determine its macro-scale homogenized mechanical properties and, thus, its biological performance as a biomaterial. In this study, we used analytical, numerical, and experimental techniques to study the elastic modulus, Poisson`s ratio, and yield stress of AM porous biomaterials made by repeating the same octahedral unit cell in all spatial directions. Analytical relationships were obtained based on both Euler-Bernoulli and Timoshenko beam theories by studying a single unit cell experiencing the loads and boundary conditions sensed in an infinite lattice structure. Both single unit cells and corresponding lattice structures were manufactured using AM and mechanically tested under compression to determine the experimental values of mechanical properties. Finite element models of both single unit cell and lattice structure were also built to estimate their mechanical properties numerically. Differences in the bulk mechanical properties of struts built in different directions were observed experimentally and were taken into account in derivation of the analytical solutions. Although the analytical and numerical results were generally in good agreement, the mechanical properties obtained by the Timoshenko beam theory were closer to numerical results. The maximum difference between analytical and numerical results for elastic modulus and Poisson's ratio was below 6%, while for yield stress it was about 13%, both occurring at the relative density of 50%. The maximum difference between the analytical and experimental values of the elastic modulus was <15% (relative density=50%).