Dissimilar welding of nickel-based Alloy 690 to SUS 304L with Ti addition

• Published in: Journal of nuclear materials Vol. 335; no. 1; pp. 59 - 69
• Main Authors: Lee, H.T., Jeng, S.L., Yen, C.H., Kuo, T.Y.
• Format: Journal Article
• Language: English
• Published: Amsterdam Elsevier B.V 01.10.2004; Elsevier
• Subjects: Applied sciences; Controled nuclear fusion plants; Energy; Energy. Thermal use of fuels; Exact sciences and technology; Fission nuclear power plants; Fuels; Installations for energy generation and conversion: thermal and electrical energy; Nuclear fuels; N0300; M0500; S0600; J0100; Welding; Mechanical properties; Oxides; Spacing; Iron; Shielding; Tensile strength; Nuclear reactor; Weld; Nuclear fusion reactor; Microstructure; Protective coatings; Nickel alloy
• ISSN: 0022-3115; 1873-4820
• DOI: 10.1016/j.jnucmat.2004.06.004

This study investigates the effects of Ti addition on the weldability, microstructure and mechanical properties of a dissimilar weldment of Alloy 690 and SUS 304L. Shielding metal arc welding (SMAW) is employed to butt-weld two plates with three welding layers, where each layer is deposited in a single pass. To investigate the effects of Ti addition, the flux coatings of the electrodes used in the welding process are modified by varying additions of either a Ti–Fe compound or a Ti powder. The results indicate that the microstructure of the fusion zone (FZ) is primarily dendritic. With increasing Ti content, it is noted that the microstructure changes from a columnar dendritic to an equiaxed dendritic, in which the primary dendrite arm spacing (PDAS) becomes shorter. Furthermore, it is observed that the amount of Al–Ti oxide phase increases in the inter-dendritic region, while the amount of Nb-rich phase decreases. Moreover, the average hardness of the FZ increases slightly. The results indicate that Ti addition prompts a significant increase in the elongation of the weldment (i.e. 36.5%, Ti: 0.41 wt%), although the tensile strength remains relatively unchanged. However, at an increased Ti content of 0.91 wt%, an obvious reduction in the tensile strength is noted, which can be attributed to a general reduction in the weldability of the joint.