Nanostructure and anisotropy of 3D printed lyotropic liquid crystals studied by scattering and birefringence imaging

• Published in: Additive manufacturing Vol. 47; p. 102289
• Main Authors: Rodriguez-Palomo, Adrian, Lutz-Bueno, Viviane, Guizar-Sicairos, Manuel, Kádár, Roland, Andersson, Martin, Liebi, Marianne
• Format: Journal Article
• Language: English
• Published: Elsevier B.V 01.11.2021
• Subjects: 3D printing; Birefringence; Lyotropic liquid crystals; Scanning SAXS; Self-assembly; Self-assembly; Lyotropic liquid crystals; Lα; G; H1; Scanning SAXS; Birefringence; 3D printing; SAXS
• ISSN: 2214-8604; 2214-7810
• DOI: 10.1016/j.addma.2021.102289

Extrusion-based 3D printing of hexagonal and lamellar lyotropic liquid crystals is a powerful technique to produce hierarchical materials with well-defined anisotropic structure. Tailoring the properties of 3D printed objects requires a precise control of the nanostructure; however, a sufficiently high degree of anisotropy is often not achieved. In this study, scanning small angle X-ray scattering was performed in situ at the exit of the needle during 3D printing. We study the induced anisotropy and nanostructure in hexagonal and lamellar lyotropic liquid crystals. Mapping of extruded filaments during printing revealed that narrower nozzle diameters (370 µm) resulted in less anisotropic structures with a wider distribution of orientation angles across the cross section, while larger nozzle diameters (550 µm) resulted in more anisotropic structures with an overall higher degree of orientation. The apparent wall shear rate is higher for the narrower nozzle, which produces wall slip, resulting in a highly anisotropic shell, and a less aligned filament core. Further examination of the filaments revealed phase transitions due to solvent evaporation. The time scales were of 10–20 min of exposure to atmospheric conditions. Simultaneously, a loss in the macroscopic anisotropy of the hexagonal self-assembled structure was observed. These processes occur during and after extrusion-based 3D printing of liquid crystals and limit the fine control of the final structure. The variability of structures achieved for our different systems highlights the importance of structural characterization during and after extrusion to guarantee high anisotropy and well-defined structures. [Display omitted]