Enhanced creep properties of copper and its alloys processed by ECAP

• Published in: IOP conference series. Materials Science and Engineering Vol. 63; no. 1; p. 12141
• Main Authors: Dvorak, J, Kral, P, Svoboda, M, Kvapilova, M, Sklenicka, V
• Format: Journal Article
• Language: English
• Published: Bristol IOP Publishing 08.08.2014
• Subjects: Binary alloys; Copper; Creep life; Creep rate; Creep strength; Creep tests; Electron backscatter diffraction; Electron microscopy; Equal channel angular pressing; Microscopy; Microstructure; Room temperature; Tensile creep; Ultrafines; Zirconium
• ISSN: 1757-8981; 1757-899X
• DOI: 10.1088/1757-899X/63/1/012141

This work describes the effect of equal channel angular pressing (ECAP) on the microstructure and creep properties of pure copper and its two binary alloys with addition of small amounts of Zr or Co. The ECAP pressing was performed at room temperature by route Bc up to 12 passes using a die with an internal angle of 90° between the two parts of the channel. Ultrafine-grained (UFG) microstructure formed through ECAP process has been studied by methods of transmission electron microscopy (TEM) and scanning electron microscopy (SEM) equipped with the electron backscatter diffraction (EBSD) unit. Tensile creep tests were conducted in tension at temperature 673 K and at different applied stresses on ECAP material and, for comparison purposes, on unpressed coarse-grained states of materials under investigation too. It was found that both alloys processed by ECAP exhibited similar character of creep behaviour. Creep resistance was markedly improved after first two ECAP passes in comparison with creep behaviour of unpressed materials. The minimum creep rate of ECAP material may be up to two orders of magnitude lower than that of unpressed material. However, subsequent ECAP passes lead to a decline of creep life and the difference in the minimum creep rate for the ECAP material and unpressed state consistently decreases with increasing number of ECAP passes. Further, ECAP process led to significant improvements in fracture strain. The link between microstructural processes and creep behaviour of pressed copper and its selected alloys is examined in detail.