Mechanical behavior of ultrafine-grained eutectoid steel containing Nano-cementite particles

• Published in: Materials science & engineering. A, Structural materials : properties, microstructure and processing Vol. 713; pp. 35 - 42
• Main Authors: Zheng, Chengsi, Li, Longfei
• Format: Journal Article
• Language: English
• Published: Lausanne Elsevier B.V 24.01.2018; Elsevier BV
• Subjects: Annealing; Cementite; Cements; Deformation; Deformation mechanisms; Dislocations; Eutectoid steel; Ferrite; Ferrites; Hardening rate; Martensite; Mathematical models; Mechanical properties; Microstructure; Nano-cementite particles; Necking; Substructures; True strain; Warm deformation of martensite; Work-hardening; Yield strength; Warm deformation of martensite; Nano-cementite particles; Eutectoid steel; Yield strength; Work-hardening
• ISSN: 0921-5093; 1873-4936
• DOI: 10.1016/j.msea.2017.12.051

A eutectoid steel with an ultrafine-grained ferrite (α) + submicron/Nano-cementite particle (θ) structure was formed by combining warm deformation of martensite to a strain of 0.36 at 0.1s−1 at 500°C with subsequent annealing at 500°C for 6h. The characteristics of the microstructure were investigated by means of a scanning electronic microscope and transmission electron microscope, and the corresponding mechanical behavior was analyzed in comparison with that of the eutectoid steel with a typical ultrafine-grained α + θ structure. The results show that both ferrite matrix and cementite particles of the ultrafine-grained α + submicron/Nano-θ steel are finer than that of the ultrafine-grained α + θ steel, i.e., the average size of approximately 0.54µm vs. 1.0µm and 0.20µm vs. 0.56µm, accompanying with a continuous yielding and a discontinuous yielding, respectively. The yield strength of the ultrafine-grained α + submicron/Nano-θ steel is 264MPa higher that of the ultrafine-grained α + θ steel, i.e., 884MPa vs. 620MPa, resulting from the enhancement caused by refined ferrite grains and cementite particles. The intragranular cementite particles within the ultrafine-grained α + submicron/Nano-θ steel are in Nano-scale, i.e., an average size of approximately 60nm, resulting in plenty of geometrically necessary dislocations (GNDs) to bring its work-hardening rate higher than that of the ultrafine-grained α + θ steel during uniform deformation. As a result, the stress increments caused by work-hardening are 89MPa and 155MPa for the ultrafine-grained α + θ steel and the ultrafine-grained α + submicron/Nano-θ steel, respectively, and their interval length of uniform strain range are nearly equal, i.e., a true strain of approximately 0.08. The work-hardening rate of the ultrafine-grained α + θ steel decline continuously with the increase of tensile strain during uniform deformation. However, the ultrafine-grained α + submicron/Nano-θ steel shows that the work-hardening rate decrease rapidly at the initial stage of work-hardening and then raise within a small strain range, then following by a slowly continuous decline to necking, and, namely, there has a peak of work-hardening rate. Furthermore, the work-hardening rate curve were divided into three stages, and the work-hardening behavior of Stage I, II and III were discussed in view of the evolution of dislocation substructures and the analytical model based on the Kocks-Mecking model.