Effects of subtransus heat treatments on microstructure features and mechanical properties of wire and arc additive manufactured Ti–6Al–4V alloy

• Published in: Materials science & engineering. A, Structural materials : properties, microstructure and processing Vol. 776; p. 139020
• Main Authors: Wang, Jian, Lin, Xin, Wang, Meng, Li, Jiaqiang, Wang, Chong, Huang, Weidong
• Format: Journal Article
• Language: English
• Published: Lausanne Elsevier B.V 03.03.2020; Elsevier BV
• Subjects: Air conditioning; Air cooling; Arc heating; Crystallography; Dispersion; Elongation; Heat treating; Heat treatment; Heat treatments; Martensite; Mechanical properties; Microstructure; Phase distribution; Titanium base alloys; Ultimate tensile strength; Water quenching; Wire; Wire and arc additive manufacturing; Mechanical properties; Wire and arc additive manufacturing; Microstructure; Heat treatments
• ISSN: 0921-5093; 1873-4936
• DOI: 10.1016/j.msea.2020.139020

Post heat treatment is necessary to optimize the microstructure of additive manufactured Ti–6Al–4V to satisfy the aeronautical criterion. However, the relationship between the unique heat treated microstructure features and corresponding mechanical properties of wire and arc additive manufactured (WAAMed) Ti–6Al–4V has not been completely understood so far. In this study, five subtransus heat treatment regimes were used to the WAAMed Ti–6Al–4V alloy, and the different heat treated microstructure and the resultant mechanical properties were investigated. The microstructure was not substantially changed after heat treatment 600 °C/4 h/air cooling (AC). The α laths were coarsened after heat treatment 850 °C/2 h/AC, and the higher annealing temperature contributed to the appearance of αs. After solution and aging treatment, there were the discontinuous αGB, coarsened αp, and fine αs. There was the small Widmanstätten structural αs sharing the uniform crystallographic orientation after heat treatment 930 °C/1 h/AC + 550 °C/4 h/AC. The α′ martensite and extremely fine dispersed granular αs were obtained after heat treatment 930 °C/1 h/water quenching (WQ) + 550 °C/4 h/AC. The heat treatment 930 °C/1 h/WQ + 800 °C/2 h/AC was found to be the best heat treatment in this study. The discontinuous αGB, dispersed αs with various crystallographic orientations were obtained, which simultaneously increased the ultimate tensile strength (UTS) and elongation (EL) to 886 ± 8 MPa and 16.6 ± 1.6%, comparing to 847 ± 12 MPa and 12.2 ± 2.8% for the as-deposited specimen. Besides, the α/β interface phase distribution in the as-deposited and heat treated specimens was concerned. Two break-up mechanisms of αp, including boundary splitting and termination migration, were observed and discussed. •The UTS and EL were simultaneously increased by heat treatment.•The strengthening mechanisms of unique heat treated microstructure were clarified.•Two mechanisms of αp break-up were identified and investigated in heat treated specimens.•The α/β interface phase in the as-deposited and heat treated specimens was observed and discussed.