Copper oxide nanofibres for detection of hydrogen peroxide vapour at high concentrations

• Published in: Physica status solidi. A, Applications and materials science Vol. 210; no. 5; pp. 859 - 863
• Main Authors: Hennemann, Jörg, Kohl, Claus-Dieter, Reisert, Steffen, Kirchner, Patrick, Schöning, Michael J.
• Format: Journal Article
• Language: English
• Published: Weinheim Blackwell Publishing Ltd 01.05.2013; Wiley Subscription Services, Inc
• Subjects: copper oxide; Exposure; Fibers; Fibres; gas sensor; Hydrogen peroxide; Operating temperature; Porosity; Sensors; Vapour
• ISSN: 1862-6300; 1862-6319
• DOI: 10.1002/pssa.201200775

We present a sensor concept based on copper(II)oxide (CuO) nanofibres for the detection of hydrogen peroxide (H2O2) vapour in the percent per volume (% v/v) range. The fibres were produced by using the electrospinning technique. To avoid water condensation in the pores, the fibres were initially modified by an exposure to H2S to get an enclosed surface. By a thermal treatment at 350 °C the fibres were oxidised back to CuO. Thereby, the visible pores disappear which was verified by SEM analysis. The fibres show a decrease of resistance with increasing H2O2 concentration which is due to the fact that hydrogen peroxide is an oxidising gas and CuO a p‐type semiconductor. The sensor shows a change of resistance within the minute range to the exposure until the maximum concentration of 6.9% v/v H2O2. At operating temperatures below 450 °C the corresponding sensor response to a concentration of 4.1% v/v increases. The sensor shows a good reproducibility of the signal at different measurements. CuO seems to be a suitable candidate for the detection of H2O2 vapour at high concentrations. Resistance behaviour of the sensor under exposure to H2O2 vapours between 2.3 and 6.9% v/v at an operating temperature of 450 °C.