Dense strontium hexaferrite-based permanent magnet composites assisted by cold sintering process

• Published in: Journal of alloys and compounds Vol. 917; p. 165531
• Main Authors: García-Martín, Eduardo, Granados-Miralles, Cecilia, Ruiz-Gómez, Sandra, Pérez, Lucas, del Campo, Adolfo, Guzmán-Mínguez, Jesús Carlos, de Julián Fernández, César, Quesada, Adrián, Fernández, José F., Serrano, Aida
• Format: Journal Article
• Language: English
• Published: Lausanne Elsevier B.V 05.10.2022; Elsevier BV
• Subjects: Coercivity; Cold pressing; Cold sintering; Cold sintering process; Composite materials; Composites; Critical point; Environmental impact; Grain size; Heat treatment; Hexaferrites; Magnetic properties; Magnetism; Permanent magnets; Phase transitions; Rare earth elements; Rare-earth-free permanent magnets; Sintering; Specific gravity; Composites; Cold sintering process; Rare-earth-free permanent magnets; Hexaferrites; Magnetic properties
• ISSN: 0925-8388; 1873-4669
• DOI: 10.1016/j.jallcom.2022.165531

The use of rare-earth-based permanent magnets is one of the critical points for the development of the current technology. On the one hand, industry of the rare-earths is highly polluting due to the negative environmental impact of their extraction and, on the other hand, the sector is potentially dependent on China. Therefore, investigation is required both in the development of rare-earth-free permanent magnets and in sintering processes that enable their greener fabrication with attractive magnetic properties at a more competitive price. This work presents the use of a cold sintering process (CSP) followed by a post-annealing at 1100 °C as a new way to sinter composite permanent magnets based on strontium ferrite (SFO). Composites that incorporate a percentage ≤ 10% of an additional magnetic phase have been prepared and the morphological, structural and magnetic properties have been evaluated after each stage of the process. CSP induces a phase transformation of SFO in the composites, which is partially recovered by the post-thermal treatment improving the relative density to 92% and the magnetic response of the final magnets with a coercivity of up to 3.0 kOe. Control of the magnetic properties is possible through the composition and the grain size in the sintered magnets. These attractive results show the potential of the sintering approach as an alternative to develop modern rare-earth-free composite permanent magnets. [Display omitted] •First dense rare-earth-free composite permanent magnets assisted by cold sintering process.•Control of the grain size during the manufacturing route of the final magnets improving their magnetic response.•Highly competitive magnetic properties reached at lower sintering temperatures with an energy efficiency of around 29%.