Effect of carbon on cryogenic tensile behavior of CoCrFeMnNi-type high entropy alloys

• Published in: Journal of alloys and compounds Vol. 811; p. 152000
• Main Authors: Klimova, M.V., Semenyuk, A.O., Shaysultanov, D.G., Salishchev, G.A., Zherebtsov, S.V., Stepanov, N.D.
• Format: Journal Article
• Language: English
• Published: Lausanne Elsevier B.V 30.11.2019; Elsevier BV
• Subjects: Alloys; Carbon; Carbon content; Cryogenic effects; Cryogenic properties; Cryogenic temperature; Dislocations; Ductility; High entropy alloys; Inclination; Interstitial alloys; Mechanical properties; Microstructure; Plastic deformation; Segregations; Slip; Solid solutions; Solution strengthening; Transmission electron microscopy; High entropy alloys; Interstitial alloys; Mechanical properties; Transmission electron microscopy; Microstructure
• ISSN: 0925-8388; 1873-4669
• DOI: 10.1016/j.jallcom.2019.152000

High entropy alloys (HEAs) with a face-centered cubic (fcc) structure are considered as promising structural materials, in particular due to their impressive ductility and toughness at cryogenic temperature; at the same time strength of these HEAs is often quite low. An addition of interstitial elements like carbon substantially increases the strength of the fcc HEAs at room temperature, however the effect of C on cryogenic properties has not been properly studied. Therefore in this work we examined cryogenic tensile behavior of the fcc high entropy alloys with different carbon content (0–2 at.%). The alloys had non-equiatomic proportions of principal elements, i.e. Co1Cr0.25Fe1Mn1Ni1. The lower Cr concentration in comparison with the equiatomic alloy led to the higher solubility of carbon confirmed by both ThermoCalc calculations and experimental results; only in the alloy with 2 at.% C a small (<1%) fraction of Cr-rich M7C3 carbides was found in the as-cast condition. The microstructure of the alloys was not significantly affected by the carbon content and generally consisted of coarse (250–300 μm) fcc phase grains with dendritic segregations. In turn, the carbon content influenced on mechanical behavior substantially: the strength of the alloys progressively increased with the carbon content along with some reduction in ductility. Solid solution strengthening by carbon at 77 K was much stronger than that at room temperature: 67 MPa/at% and 178 MPa/at%, respectively. The increase in solid solution strengthening agreed well with an anticipated increase in lattice friction at lower temperatures. Plastic deformation was associated with dislocations slip both at 293 K and 77 K; a decrease in temperature and an increase in the carbon concentration increased the inclination to planar slip. The obtained results offer new approaches to increase the cryogenic properties of fcc HEAs. [Display omitted] •Co1Cr0.25Fe1Mn1Ni1 high entropy alloys with 0–2 at.% C produced by induction melting.•High solubility of C in the fcc matrix of the alloys due to reduced Cr concentration.•Addition of C and lower deformation temperature pronouncedly increased strength.•Solid solution strengthening was 67 MPa/at% C at 293 K and 178 MPa/at% C at 77 K.•Dislocations slip mediated plastic deformation both at 293 K and 77 K.