Transverse Bending Characteristics in U-channel Forming of Tailor Rolled Blank

• Published in: Journal of iron and steel research, international Vol. 23; no. 12; pp. 1249 - 1254
• Main Authors: ZHANG, Hua-wei, GUAN, Ying-ping, WU, Jia-lu, LIU, Xiang-hua
• Format: Journal Article
• Language: English
• Published: Singapore Elsevier Ltd 01.12.2016; Springer Singapore
• Subjects: annealing; Applied and Technical Physics; Engineering; Machines; Manufacturing; Materials Engineering; Materials Science; Metallic Materials; Metallurgy and Metal Working; Physical Chemistry; Processes; springback; tailor rolled blank; thickness transition zone; transverse bending; TRB; U-channel; 弯曲回弹; 弯曲特性; 成形性能; 裁缝; 轧坯; 通道; U-channel; transverse bending; thickness transition zone; annealing; springback; tailor rolled blank
• ISSN: 1006-706X; 2210-3988
• DOI: 10.1016/S1006-706X(16)30184-4

Research on the formability of tailor rolled blank (TRB) is of good practical significance and application value because of the enormous potential of TRB in the aspect of automobile lightweight. However, the forming of TRB is problematic because of the varying properties; especially, springback is a main challenge. The transverse bending (bending axis is perpendicular to the rolling direction) of TRB U-channel was studied through simulation and experiment. The forming characteristics of TRB U-channel during transverse bending were analyzed. The mechanisms of forming defects, including bending springback and thickness transition zone (TTZ) movement, were revealed. On this basis, effects of blank geometric parameters on springback and TTZ movement were discussed. The results indicate that springback and TTZ movement happen during transverse bending of TRB U-channel. Nonuniform stress distribution is the most fundamental reason for the occurrence of springback of TRB during transverse bending. Annealing can eliminate nonuniform stress distribution, and thus diminish springback of TRB, especially springback on the thinner side. Therefore, springback of the whole TRB becomes more uniform. However, annealing can increase the TTZ movement. Blank thickness and TTZ position are the main factors affecting the formability of TRB U-channel during transverse bending.