Effect of molecular weight on the EUV-printability of main chain scission type polymers
Unclear light-matter interactions in the Extreme UV lithography (EUVL) process cause the sub-optimal performance of the current photoresist platforms. Furthermore, adopting conventional chemically amplified resist (CAR) is problematic in EUVL because of the exacerbated stochastic effects. Therefore,...
Saved in:
Published in | Journal of materials chemistry. C, Materials for optical and electronic devices Vol. 8; no. 17; pp. 5958 - 5966 |
---|---|
Main Authors | , , , , , |
Format | Journal Article |
Language | English |
Published |
Cambridge
Royal Society of Chemistry
07.05.2020
|
Subjects | |
Online Access | Get full text |
Cover
Loading…
Summary: | Unclear light-matter interactions in the Extreme UV lithography (EUVL) process cause the sub-optimal performance of the current photoresist platforms. Furthermore, adopting conventional chemically amplified resist (CAR) is problematic in EUVL because of the exacerbated stochastic effects. Therefore, alternative platforms with simpler chemistry, such as the main chain scission (MCS)-type photoresist, can pave the way for efficient printability at higher resolutions. In this work, fundamental analysis of a simple MCS-type photoresist - polymethyl methacrylate (PMMA), is studied and correlated with the parameters of EUV-patterning (called litho-parameters). Contrast curve analysis with different solvents shows MIBK-IPA (1 : 3) mixture as the best developer for EUV-patterning of PMMA. Higher
M
w
(950k) shows the best EUV-printability compared to the lower
M
w
(15k, 120k, and 600k) PMMA for 50 nm dense line-space (L/S). To understand the effect of polymer properties on printability, desorption and Gel Permeation chromatography (GPC) studies are conducted, which show that the higher
M
w
PMMA provides better litho-parameters (higher MCS - to - side-chain scission (SCS) ratio, higher GPC peak shift, and lower GPC peak overlap after EUV-exposure) compared to the lower
M
w
PMMA. Additionally, it is found that the PMMA chains require minimum energy of 9 eV to induce chemical reactions in the film. The main hypothesis obtained from this study is that for MCS-type EUV resists, higher
M
w
material provides better printability than the lower
M
w
material. This is further validated on an engineered MCS-copolymer system. Finally, it is observed that the inhomogeneous dose-deposition during EUV-exposures might hamper the printability of the MCS-type resist.
This study on the main chain scission type polymers, PMMA and a copolymer system, shows that the EUV-printability is proportional to the
M
w
of the starting material, which is attributed to the enhanced litho-parameters of higher
M
w
material. |
---|---|
Bibliography: | 10.1039/c9tc06482f Electronic supplementary information (ESI) available. See DOI |
ISSN: | 2050-7526 2050-7534 |
DOI: | 10.1039/c9tc06482f |