Experimental study to investigate microstructure and continuous strain rate sensitivity of structural steel weld zone using nanoindentation

• Published in: International journal of mechanical sciences Vol. 174; p. 105482
• Main Authors: Nguyen, Ngoc-Vinh, Kim, Seung-Eock
• Format: Journal Article
• Language: English
• Published: Elsevier Ltd 15.05.2020
• Subjects: Continuous strain rate sensitivity; Dislocation behavior; Indentation size effect; Nanoindentation; Strain rate effect; Weld zone; Dislocation behavior; Indentation size effect; Weld zone; Continuous strain rate sensitivity; Strain rate effect; Nanoindentation
• ISSN: 0020-7403; 1879-2162
• DOI: 10.1016/j.ijmecsci.2020.105482

•Variation of microstructure in the weld zone and pile-up phenomenon were observed.•Hardness depended not only on indentation size but also on strain rate indentation.•Both hardness and SRS of WM, HAZ, and BM showed the depth-dependent behavior.•SRS value of WM is lower than those in BM and HAZ at larger indents.•Continuous SRS in the weld zone is attributed to the change in dislocation behavior. In this study, a series of experiments consisting of continuous stiffness measurement (CSM) nanoindentation experiments, optical microscope (OM), atomic force microscopy (AFM) examinations, and finite element (FE) analysis were performed to study the microstructures, the indentation size effects, and the rate-dependent behavior of mechanical properties in three phases of SM490 structural steel weld joint. The microstructures of base metal (BM), heat-affected zone (HAZ), and weld metal (WM) were observed using OM examinations. The size-dependent behaviors of mechanical properties in BM, HAZ, and WM were characterized and interpreted through the strain gradient theory. The CSM nanoindentation experiments were carried out in the strain rate range of 0.01–0.1 s−1 to investigate the rate-dependent behavior of indentation hardness and continuous strain rate sensitivity. The results indicated that indentation hardness depended on not only the indentation size but also the strain rate of the indentation level. The strain rate sensitivity (SRS) of BM, HAZ, and WM showed the depth-dependent behavior. The SRS of WM is quite high, over 0.4 at the indentation depth of 200 nm, quickly drops to 0.1, and finally is around 0.0298 at large indents. Similarly, the SRS behavior in the case of HAZ is the same, however, the SRS values at larger indents are higher than those obtained in the WM region. At larger depths, the SRS values of the WM region are lower than those of BM and HAZ, while BM has the highest SRS value compared with WM and HAZ. The continuous SRSs of WM, HAZ, and BM are attributed to the change in the dislocation behaviors during the indentation process. The results of the present study can be used to access and understand the rate- and the size-dependent behaviors in structural steel weld zone. [Display omitted]