Aging kinetics and mechanical properties of copper-bearing low-carbon HSLA-100 microalloyed steel

• Published in: Archives of Civil and Mechanical Engineering Vol. 19; no. 4; pp. 1409 - 1418
• Main Authors: Sohrabi, M.J., Mirzadeh, H., Mehranpour, M.S., Heydarinia, A., Razi, R.
• Format: Journal Article
• Language: English
• Published: London Elsevier B.V 01.08.2019; Springer London; Springer Nature B.V
• Subjects: Activation energy; Age hardening; Aging; Aging (metallurgy); Alpha iron; Charpy V-Notch impact test; Civil Engineering; Copper; Dislocation density; Engineering; Hardening; Heat treating; High strength low alloy steels; HSLA steel; Impact strength; Kinetics; Low carbon steels; Martensite; Mechanical Engineering; Mechanical properties; Original Research Article; Secondary hardening; Structural Materials; Tensile properties; Secondary hardening; Age hardening; Tensile properties; Charpy V-Notch impact test; HSLA steel
• ISSN: 1644-9665; 2083-3318
• DOI: 10.1016/j.acme.2019.09.001

The precipitation kinetics of HSLA-100 steel and the correlation between tensile and impact properties were studied. According to the modified Johnson–Mehl–Avrami–Kolmogorov (JMAK) analysis and based on the analysis of the time corresponding to the transformed fraction of 0.5 (t0.5), the activation energy for the precipitation of copper during aging of martensite was determined as ˜111 and 105 kJ/mol, respectively. These values are much smaller than the activation energy for the diffusion of Cu in α-iron, which was related to the effect of high dislocation density of the quenched martensitic microstructure on the aging process. These results were verified based on the diffusional calculations. Based on the analysis of mechanical behavior, no reasonable correlation was found between strength of the material and the impact energy. However, the impact energy was found to be proportional to the UTS-YS, where the latter is an indicator of the work-hardening capability of the material. This revealed that the work-hardening capacity of the material is a much more important factor for determining the impact toughness compared to its strength.