A paper-based inkjet-printed PEDOT:PSS/ZnO sol-gel hydrazine sensor

• Published in: Sensors and actuators. B, Chemical Vol. 306; p. 127539
• Main Authors: Beduk, Tutku, Bihar, Eloise, Surya, Sandeep G., Castillo, Aminta N., Inal, Sahika, Salama, Khaled N.
• Format: Journal Article
• Language: English
• Published: Lausanne Elsevier B.V 01.03.2020; Elsevier Science Ltd
• Subjects: Blowing agents; Electrical measurement; Electrochemical analysis; Electrodes; Hydrazine sensor; Hydrazines; Inkjet printing; Low concentrations; Paper electronics; PEDOT:PSS; Pesticides; Point-of-care sensor; Polystyrene resins; Sensitivity; Sensors; Sol-gel processes; Sol–gel; Zinc oxide; Zinc oxides; Point-of-care sensor; Inkjet printing; Zinc oxide; Hydrazine sensor; Sol–gel; Paper electronics; PEDOT:PSS
• ISSN: 0925-4005; 1873-3077
• DOI: 10.1016/j.snb.2019.127539

[Display omitted] •The preparation of fully inkjet printed PEDOT:PSS/ZnO/Nafion sensor on commercial printing paper..•A paper based electrochemical sensor for hydrazine sensing with a good selectivity and reproducibility.•Sensitivity comparison of PEDOT:PSS/Nafion and PEDOT:PSS/ZnO/Nafion sensors.•Characterization of PEDOT:PSS and ZnO through SEM, XPS and AFM.•Excellent detection in real samples with a recovery of 98.7–104.2 %. Hydrazine is widely used in industries as a precursor for blowing agents, pharmaceuticals, and pesticides. It is a highly toxic compound; therefore, it is of paramount interest to develop new analytical methods for the detection and control of hydrazine exposure. In this work, we describe the fabrication of an all inkjet-printed paper sensor composed of poly(3,4-ethylenedioxythiophene):poly(styrene sulfonate) (PEDOT:PSS) electrode functionalized with zinc oxide (ZnO) and encapsulated in a Nafion matrix for the amperometric determination of low concentrations of hydrazine. The electrochemical properties of the fully inkjet-printed PEDOT:PSS/Nafion and PEDOT:PSS/ZnO/Nafion sensors are compared in the presence and absence of different concentrations of hydrazine. The stability and sensitivity of these electrodes are significantly enhanced after modification with ZnO particles. The layer-by-layer deposition of the materials on the electrode surface is characterized by SEM, XRD, and AFM. The printed sensor exhibits a linear response in the 10–500 μM hydrazine concentration range and a ∼5 μM detection limit (at S/N = 3). The electrochemical sensitivity is 0.14 μA μM−1 cm−2, and the best working voltage is 0.5 V. The developed sensor was applied successfully for the determination of hydrazine content in tap, sea, and mineral water samples validating the accuracy of this sensor.