A Study on Color of Thermosetting Resin for Veneer Crown

• Published in: Nihon Hotetsu Shika Gakkai Zasshi Vol. 33; no. 1; pp. 193 - 207
• Main Author: Kamitomai, Hiroshi
• Format: Journal Article
• Language: Japanese
• Published: Japan Japan Prosthodontic Society 01.02.1989
• Subjects: CIE colorimetric system; Color - standards; color difference; Colorimetry; Crowns; Dental Veneers; Resins, Synthetic; thermosetting resin; veneer crown
• ISSN: 0389-5386; 1883-177X
• DOI: 10.2186/jjps.33.193

Based on the viewpoint that stresses the importance of achieving natural colors and forms for veneer crown, four representative kinds of thermosetting resins were investigated colorimetrically in an attempt to clarify the relationship between the thickness and color of resins in opaque, dentin and enamel colors respectively. A spectrophotometer was used to measure the colors, the CIE colorimetric system employed to show the readings, and the CIE 1964 U*V*W* space was utilized to indicate the color differences, with the following results. 1. In the case of dentin, certain specific colors were observed for thicknesses of 1.3 to 1.8 mm when used alone, but when applied over opaque the range was 0.2 to 0.5 mm lower than when used alone.2. Enamel resins were grouped into two types according to different color groups, one group similar to achromatic color with low limpidity and the other similar to the dentin color with high limpidity. The former type became more grayer with an increase in thickness when applied over dentin. The latter type showed no difference in color even when the thickness increased. This study has shown that the facing color results vary depending on the color properties of the different resins used. Therefore, it is advisable that careful consideration be given to these differencies in order to achieve the intended color facing.