Feasibility study of a novel multi-container extrusion method for manufacturing wide aluminium profiles with low force

• Published in: Journal of manufacturing processes Vol. 85; pp. 584 - 593
• Main Authors: Lv, Jiaxin, Yu, Junquan, Shi, Zhusheng, Li, Weishu, Lin, Jianguo
• Format: Journal Article
• Language: English
• Published: Elsevier Ltd 06.01.2023
• Subjects: Die design; Extrusion; Extrusion force; Multi-billet; Welding quality; Wide aluminium profile; Multi-billet; Extrusion; Extrusion force; Welding quality; Wide aluminium profile; Die design
• ISSN: 1526-6125; 2212-4616
• DOI: 10.1016/j.jmapro.2022.11.055

Extrusion profiles are extensively used in industries and any improvement in the process could potentially have a large impact on energy and cost savings. In this study, a novel extrusion method, namely multi-container extrusion, was proposed for producing thin-walled wide aluminium components with low force. Its basic principle is to enable multiple billets to be welded and forced through die orifice simultaneously. To demonstrate its feasibility, a series of studies have been conducted including the experimental design and set-up of multi-container extrusion, microstructural and mechanical characterisations of the extruded components, and the comparison with the existing extrusion method. A three-container extrusion tooling was designed and manufactured to produce wide hollow profiles with plasticine and aluminium alloy AA6063. Optical microscopic observations and tensile tests were carried out for different positions of AA6063 extrudates. For the specimens near the extrudate front (8 mm and 23 mm away), tensile fractures occurred exactly along the distinct welds which were formed when individual billets met inside the die during extrusion. Further away from the extrudate front (83 mm, 98 mm and 113 mm), the welds were hardly observed, and the tensile fractures occurred outside the welds, indicating that good welding quality can be obtained in the multi-container extrusion process. Compared with the conventional porthole extrusion method, three-container extrusion could significantly reduce the required force to about 15 % for extruding the same profile. This study demonstrates that the proposed multi-container extrusion method can form wide profiles and greatly reduce the extrusion force requirement. [Display omitted] •A novel multi-container extrusion method was proposed for manufacturing wide profiles.•The feasibility of the proposal was demonstrated by three-container extrusion tests.•The three-container extrusion requires significantly lower force than conventional one.•Good welding quality has been achieved in the extruded profile.