Textile-based triboelectric nanogenerators via electroless plating for fabricating electrode material: Study of the relationship between electrostatic-charge density and strain in dielectric material

• Published in: Composites science and technology Vol. 218; p. 109187
• Main Authors: Gui, Chengmei, Zhang, Ruxia, Chen, Zhenming, Wu, Wangping, Li, Honglin, Huang, Junjun
• Format: Journal Article
• Language: English
• Published: Barking Elsevier Ltd 08.02.2022; Elsevier BV
• Subjects: Adsorption; Charge density; Cotton; Dielectrics; Electrode material; Electrode materials; Electrodes; Electroless nickel plating; Electroless plating; Electrostatic charge; Electrostatic-charge density; Equations of state; Nanogenerators; Open circuit voltage; Plating; Polydimethylsiloxane; Sheaths; Strain; Triboelectric nanogenerators; Yarn; Triboelectric nanogenerators; Electrostatic-charge density; Electrode material; Electroless plating; Strain
• ISSN: 0266-3538; 1879-1050
• DOI: 10.1016/j.compscitech.2021.109187

Textile-based cotton was developed to fabricate the support for triboelectric nanogenerators (TENGs), which would facilitate the improvement of the device wearability and comfort. But, it is difficult to achieve the fabrication of metal textile-based cotton for electrode materials using traditional technology. In this regard, a textile-based TENGs via electroless plating on cotton surface for fabricating electrode material was established, the output performances under different external forces were studied comprehensively to obtain a full understanding of the relationship between the density of electrostatic charge (δ) and strain of polydimethylsiloxane (PDMS) dielectric material. Results showed that active groups on the rough cotton surface would facilitate the adsorption of Pd2+, and then reduce of Ni2+ to Ni atom in electroless nickel solution. As a result, core-sheath micronfiber yarn with weave structure was fabricated. It is flexible, lightweight, flexible with typical performance of TENGs electrode. The device had stable and excellent performances, and a maximum open-circuit voltage of about 8.3 V was observed from stress of 3.8 kPa or strain of 1.7 × 10−6 on PDMS layer. More importantly, a new calculation method for the PDMS strain of formation δ was proposed by equation of state. It was also revealed that the δ and PDMS strain represented a linear regression relation when the device under weigh mass of 0.22–0.52 kg, stress of 0.69–1.63 kPa and strain of 0.3–0.72 × 10−6. Nevertheless, further increasing stress, actual δ value is firstly higher and then lower than the theoretical value due to fabric fiber deformation. [Display omitted]