Microstructure and wear resistance of Al2O3–M7C3/Fe composite coatings produced by laser controlled reactive synthesis

• Published in: Optics and laser technology Vol. 68; pp. 11 - 17
• Main Authors: Tan, Hui, Luo, Zhen, Li, Yang, Yan, Fuyu, Duan, Rui
• Format: Journal Article
• Language: English
• Published: Elsevier Ltd 01.05.2015
• Subjects: Al2O3 ceramic; Aluminum oxide; Carbides; Ceramics; Composite coatings; Lasers; M7C3 carbide; Scanning electron microscopy; Synthesis; Thermites; Wear resistance; Al2O3 ceramic; Wear resistance; M7C3 carbide
• ISSN: 0030-3992; 1879-2545
• DOI: 10.1016/j.optlastec.2014.11.006

Based on the principle of thermite reaction of Al and Fe2O3 powders, the Al2O3 ceramic reinforced Fe-based composite coatings were fabricated on a steel substrate by laser controlled reactive synthesis and cladding. The effects of different additions of thermite reactants on the phase transition, microstructure evolution, microhardness and wear resistance of the composite coatings were investigated by means of X-ray diffraction (XRD), scanning electron microscopy (SEM), transmission electron microscopy (TEM), Vickers microhardness and block-on-ring wear test, respectively. The results show that Al2O3 ceramic and M7C3 carbide are in situ synthesized via the laser controlled reactive synthesis. The Al2O3 ceramic and M7C3 carbides prefer to distribute along the γ-Fe phase boundary continuously, which separates the γ-Fe matrix and is beneficial to the grain refinement. With the increase of thermite reactants, the amount of Al2O3 ceramic and M7C3 carbide in the composite coatings increases gradually. Moreover the cladding layer changes from dendritic structure to columnar structure and martensite structure in the heat affected zone becomes coarse. The increased thermite reactants improve the microhardness and wear resistance of the in situ composite coatings obviously and enhance the hardness of the heat affected zone, which should be ascribed to the grain refinement, ceramic and carbide precipitation and solid solution strengthening. •Al2O3–M7C3/Fe composite coatings were in situ produced by laser cladding.•Solidification process of the laser cladding composite coatings was investigated.•The Al2O3 ceramic and M7C3 carbide were determined by XRD and TEM.•The Al2O3–M7C3/Fe composite coatings exhibit good wear resistance.•The excellent wear resistance is mainly due to the presence of hard reinforcements.