Optimized ink jetted paper device for electroanalytical detection of picric acid

• Published in: Colloids and surfaces, B, Biointerfaces Vol. 208; p. 112056
• Main Authors: Mohan, Jaligam Murali, Amreen, Khairunnisa, Kulkarni, Madhusudan B., Javed, Arshad, Dubey, Satish Kumar, Goel, Sanket
• Format: Journal Article
• Language: English
• Published: Elsevier B.V 01.12.2021
• Subjects: Electroanalysis; Ink-jet printing; Paper strip; Picric acid; Picric acid; Electroanalysis; Paper strip; Ink-jet printing
• ISSN: 0927-7765; 1873-4367
• DOI: 10.1016/j.colsurfb.2021.112056

[Display omitted] •Ink-Jetted Miniaturized paper based electroanalytical device was fabricated.•ZnO nanoparticles were drop casted to modify the working electrode.•A linear range of 4 μM to 60 μM was found.•A 4.04 μM of limit of detection was within in the safe limit.•The device was tested for picric acid sensing in tap and lake water. Picric acid (PA) is one of the essential components utilized in manufacturing of explosives. Therefore, the detection of trace amount of PA is critical in forensic science, criminal investigation, military security and environmental safety. Owing to these attributes, development of a simple, rapid and point-of-care (POC) analytical method for PA detection and quantification is crucial. Herein, a low-cost, POC, ink jetted paper device has been developed for electroanalytical detection of PA. Inkjet printing is an economic fabrication process used for extruding several nanomaterials with diversified applications. By improving the ink viscosity, inkjet printers can simplify the fabrication of paper-based electrochemical sensor, and provide easy, fast, environmental friendly and viable for large scale production sensors, thereby adding its commercialization potential. In this work, a commercially available circuit board printer and an inexpensive high viscosity carbon conductive ink were used to print an electrochemical paper device. The fabricated device was used for electrochemical detection of PA using cyclic voltammetry (CV) and wave voltammetry (SWV). Various parameters like effect of potential scan rate from 10 mVs−1 to 300 mVs−1, effect of variable PA concentration effect was studied. A linear concentration range of 4 μM to 60 μM was obtained. For a working electrode of 7 mm2 surface area, the limit of detection (LOD) was 4.04 μM (922.56 ppb) which was less than the prescribed safe limit of 8 μM. Effect of interference with other chemicals was examined using SWV with the co-existing metals like zinc, lead, copper and mercury. Finally, real sample analysis for tap and lake water was successfully performed with the device. The developed cost-effective paper-based ink-jetted platform, with further fine-tuning and surface modifications, can be used for sensing various analytes as a point-of-care device.