Experimental investigation of the mechanical performances of titanium cranial prostheses manufactured by super plastic forming and single-point incremental forming

• Published in: International journal of advanced manufacturing technology Vol. 98; no. 5-8; pp. 1489 - 1503
• Main Authors: Ambrogio, G., Palumbo, G., Sgambitterra, E., Guglielmi, P., Piccininni, A., De Napoli, L., Villa, T., Fragomeni, G.
• Format: Journal Article
• Language: English
• Published: London Springer London 01.09.2018; Springer Nature B.V
• Subjects: Anchoring; CAE) and Design; Computer-Aided Engineering (CAD; Drop tests; Engineering; Forming; Forming techniques; Impact tests; Industrial and Production Engineering; Manufacturing; Mechanical analysis; Mechanical Engineering; Mechanical properties; Media Management; Original Article; Prostheses; Surgical implants; Titanium alloys; Titanium base alloys; SPF; Pure titanium; Ti-6Al-4V-ELI; SPIF; Drop test; Ti-6Al-4V
• ISSN: 0268-3768; 1433-3015
• DOI: 10.1007/s00170-018-2338-6

In the present work, sheet-forming processes, i.e. super plastic forming and single-point incremental forming, have been adopted for the manufacturing of custom prostheses, instead of subtractive and additive techniques that are time- and cost-consuming for a single-piece production. Regarding concerns of the material, three different titanium alloys were used: pure titanium and two grades of the alloy Ti-6Al-4V (the standard one and the extra low interstitial one). Since no standard protocol exists to assess the mechanical performance of cranial implants, an experimental procedure has been designed and used in this work for producing polymethylmethacrylate supports, on which the cranial prostheses were firmly connected and subjected to impact puncture tests (drop tests). An experimental campaign could thus be conducted to investigate the effect on the mechanical response of (a) the titanium alloy, (b) the initial blank thickness and (c) the manufacturing process. Drop tests, carried out according to the proposed procedure, have shown no failure of the prostheses, neither in the area of the impact nor in the anchoring region and have revealed that, irrespective of the adopted manufacturing process, which does not alter the material, the amount of energy absorbed by the implants is always larger than 70%.