Experimental investigation of the regeneration performance of an internally heated regenerator used for heating tower solution regeneration

• Published in: Energy conversion and management Vol. 189; pp. 184 - 194
• Main Authors: Song, Pengyuan, Xiao, Hansong, Wang, Baolong, Shi, Wenxing, Li, Xianting, Zhang, Guohui
• Format: Journal Article
• Language: English
• Published: Oxford Elsevier Ltd 01.06.2019; Elsevier Science Ltd
• Subjects: Air flow; Air temperature; Antifreeze solutions; Cooling towers; Desiccants; Experiment; Finned tube; Flow rates; Flow velocity; Frost; Frost-free; Heat; Heat and mass transfer; Heat exchangers; Heat pumps; Heat recovery; Heat transfer; Heating; Heating tower; Humidity; Inlet temperature; Latent heat; Mass transfer; Moisture removal; Parameters; Performance indices; Regeneration; Solution regeneration; Temperature effects; Water flow; Water treatment; Frost-free; Heat and mass transfer; Finned tube; Experiment; Heating tower; Solution regeneration
• ISSN: 0196-8904; 1879-2227
• DOI: 10.1016/j.enconman.2019.03.089

•A novel heat recovery solution regeneration system is proposed for heating tower.•Regeneration performance of internally heated regenerator is experimentally studied.•Correlations of heat and mass transfer coefficients are developed based on results.•A low-grade heat source can be used for heating tower solution regeneration. Owing to their high cooling efficiency in summer and frost-free characteristics in winter, heating tower heat pumps are becoming increasingly popular. However, the solution will be diluted during heating due to absorbing moisture from the air, and should be properly regenerated for continuous operation. In this study, a novel heat recovery solution regeneration system using an internally heated regenerator is proposed for antifreeze solution regeneration. A test bench is fabricated to investigate the regeneration performance of the internally heated regenerator. Correlations of the heat and mass transfer coefficients are proposed, and agree well with the experimental data. The influences of inlet parameters on the moisture removal rate, latent heat ratio, and humidity effectiveness are evaluated and compared to those for internally heated liquid desiccant regeneration. The results indicate that: the regeneration performance of the internally heated regenerator is affected mainly by the air flow rate, heating water flow rate, and inlet temperature of heating water. The moisture removal rate increases remarkably with increasing the heating water flow rate and inlet temperature of heating water. The latent heat ratio decreases significantly with increasing the inlet temperature of heating water. The humidity effectiveness decreases remarkably with increasing the air flow rate. The influences of the above inlet parameters on performance indices in the present study exhibit the same trends as those reported for internally heated liquid desiccant regeneration. However, compared with internally heated liquid desiccant regeneration, the regeneration temperature for internally heated antifreeze solution regeneration is much lower. This suggests that a low-grade heat source can be used to meet the antifreeze solution regeneration demands.