Influence of molybdenum on the conduction mechanism in passive films on iron–chromium alloys in sulphuric acid solution

• Published in: Electrochimica acta Vol. 46; no. 9; pp. 1339 - 1358
• Main Authors: Bojinov, Martin, Fabricius, Gunilla, Laitinen, Timo, Mäkelä, Kari, Saario, Timo, Sundholm 1, Göran
• Format: Journal Article
• Language: English
• Published: Oxford Elsevier Ltd 01.02.2001; Elsevier
• Subjects: Chemistry; Contact electric resistance technique; Electrochemistry; Electrodes: preparations and properties; Exact sciences and technology; General and physical chemistry; Impedance spectroscopy; Ionic and electronic conductivity; Iron–chromium–molybdenum alloys; Kinetic model; Other electrodes; Kinetic model; Contact electric resistance technique; Ionic and electronic conductivity; Impedance spectroscopy; Iron–chromium–molybdenum alloys; Chromium base alloys; Electrode impedance; Electronic properties; Electrode production; Electronic conductivity; Electrolyte solution; Rotating disk electrode; Ionic conductivity; Composition effect; Contact resistance; Voltammetry; Experimental study; Molybdenum base alloys; Electrochemical characteristic; Electrochemical polarization; Electrodissolution; Aqueous solution; Electrode capacity; Electrode potential; Iron base alloys
• ISSN: 0013-4686; 1873-3859
• DOI: 10.1016/S0013-4686(00)00713-1

This paper describes an extension of the mixed-conduction model to predict quantitatively the electrochemical behaviour and transport properties of anodic films on pure Cr, Fe–Cr alloys and Fe–Cr–Mo alloys in 1 M sulphuric acid solution. The anodic films on Fe–Cr–Mo alloys (12 and 25% Cr; 0, 5 and 10% Mo) were studied using rotating ring-disk voltammetry, impedance spectroscopy and resistance measurements. The addition of Mo to the Fe–Cr alloys was found to decrease the resistance of the film both in the passive and transpassive region. During the re-activation of the Fe–12%Cr– x%Mo alloys at negative potentials, soluble products were found to be released at a higher potential than during the re-activation of the Fe–12%Cr alloy. Re-activation proceeds to a lesser extent for the Fe–25%Cr alloy, and was not observed for the Fe–25%Cr– x%Mo alloys. The addition of Mo was also found to lead to a marked increase of the transpassive dissolution rate of the alloys. The impedance spectroscopic results indicated that the addition of Mo increases the rate of the interfacial generation of positive defects and especially annihilation of negative defects. The present extension of the mixed-conduction model for anodic passive films was found to describe quantitatively the resistance and impedance spectroscopic data for Fe–25%Cr and Fe–25%Cr–10%Mo alloy, as well as earlier data on pure Cr. The same kinetic model can be used to describe the behaviour of the films on all these materials. It is thus most likely that a Cr-oxide-based film is formed which determines the behaviour of the Fe–25%Cr and Fe–25%Cr–10%Mo alloys as well.