Fracture toughness of Ceramic-Fiber-Reinforced Metallic-Intermetallic-Laminate (CFR-MIL) composites

• Published in: Materials science & engineering. A, Structural materials : properties, microstructure and processing Vol. 649; pp. 407 - 416
• Main Authors: Vecchio, Kenneth S., Jiang, Fengchun
• Format: Journal Article
• Language: English
• Published: Elsevier B.V 01.01.2016
• Subjects: Bend tests; Ceramic-Fiber-Reinforced-Metal-Intermetallic-Laminate (CFR-MIL); Fracture mechanics; Fracture toughness; Intermetallics; Laminates; Microstructure; Phases; Strength; Ceramic-Fiber-Reinforced-Metal-Intermetallic-Laminate (CFR-MIL); Fracture toughness
• ISSN: 0921-5093; 1873-4936
• DOI: 10.1016/j.msea.2015.10.018

Novel Ceramic-Fiber-Reinforced-Metal-Intermetallic-Laminate (CFR-MIL) composites, Ti–Al3Ti–Al2O3–Al, were synthesized by reactive foil sintering in air. Microstructure controlled material architectures were achieved with continuous Al2O3 fibers oriented in 0° and 90° layers to form fully dense composites in which the volume fractions of all four component phases can be tailored. Bend fracture specimens were cut from the laminate plates in divider orientation, and bend tests were performed to study the fracture behavior of CFR-MIL composites under three-point and four-point bending loading conditions. The microstructures and fractured surfaces of the CFR-MIL composites were examined using optical microscopy and scanning electron microscopy to establish a correlation between the fracture toughness, fracture surface morphology and microstructures of CFR-MIL composites. The fracture and toughening mechanisms of the CFR-MIL composites are also addressed. The present experimental results indicate that the fracture toughness of CFR-MIL composites determined by three- and four-point bend loading configurations are quite similar, and increased significantly compared to MIL composites without ceramic fiber reinforcement. The interface cracking behavior is related to the volume fraction of the brittle Al3Ti phase and residual ductile Al, but the fracture toughness values appear to be insensitive to the ratio of these two phases. The toughness appears to be dominated by the ductility/strength of the Ti layers and the strength and crack bridging effect of the ceramic fibers.