Experimental investigation of hole-geometry effect on unsteady characteristics of film cooling at turbine vane leading edge

• Published in: International journal of thermal sciences Vol. 179; p. 107715
• Main Authors: Zhou, Wen-li, Pu, Jian, Wang, Jian-hua, Su, Hang, Chen, Yun
• Format: Journal Article
• Language: English
• Published: Elsevier Masson SAS 01.09.2022
• Subjects: Cooling unsteadiness; Film cooling; Leading-edge; Shaped-hole; Stagnation line; Transverse trench; Stagnation line; Leading-edge; Shaped-hole; Film cooling; Transverse trench; Cooling unsteadiness
• ISSN: 1290-0729; 1778-4166
• DOI: 10.1016/j.ijthermalsci.2022.107715

In present work, the hole-geometry effect on the unsteady characteristics of film cooling at leading-edge of a turbine vane was experimentally studied under blowing ratios (BRs) from 0.5 to 3.0. The typical double-row staggered layout was applied in the stagnation zone. Selected hole-geometries include the cylindrical-hole and fan-shaped-hole, as well as the cylindrical-holes in a transverse trench and an individual crater. Through employing the infrared thermography and planar quantitative light sheet techniques, the unsteadiness of surface film effectiveness and in-plane jet-concentration were analyzed. The level of cooling unsteadiness was estimated by the standard deviations of these scalar parameters. A comparison of both techniques revealed that the flow unsteadiness at the interface of mainstream and cooling air jet is the essence of surface film effectiveness fluctuation. Under small BRs, the fan-shaped-hole displays the best film coverages; however, adding the transverse trench can generate the highest film effectiveness under large BRs. Relative to the cylindrical-hole, the maximum increments in area-averaged effectiveness can be above 10% for both the new designs. The transverse trench design can generate the lowest-level cooling unsteadiness, and improve evidently the uniformity of film effectiveness over entire leading-edge. However, two challenges for trench design should be concerned. The first was the faster decay in film effectiveness, in comparison with the fan-shaped-hole jets. The second was the high-level cooling unsteadiness on the sidewalls of trench.