Experimental study of vibrational energy harvesting using Electro-Active paper

• Published in: International journal of precision engineering and manufacturing Vol. 16; no. 6; pp. 1187 - 1193
• Main Authors: Abas, Zafar, Kim, Heung Soo, Zhai, Lindong, Kim, Jaehwan
• Format: Journal Article
• Language: English
• Published: Seoul Korean Society for Precision Engineering 01.06.2015
• Subjects: Engineering; Industrial and Production Engineering; Materials Science; Transducer; Vibration; Energy harvesting; Frequency response function; Electro-active paper
• ISSN: 2234-7593; 2005-4602
• DOI: 10.1007/s12541-015-0153-7

This paper presents an estimation of power output produced by an Electro-Active Paper (EAPap) energy harvesting transducer under base vibration. EAPap is very thin cellulose piezoelectric film, which exhibits a direct piezoelectric effect, when subjected to stress. A 50×50 mm 2 EAPap patch was bonded on a 100×50×1 mm 3 aluminum cantilever structure. Energy harvesting tests were performed on the energy harvesting transducer, without and with a 2 grams proof mass near the tip of the cantilever beam. The voltage, current and power frequency response functions (FRFs) with respect to the base acceleration are identified and presented. The Voltage FRFs show a monotonic trend with increasing the load resistor from 100 kΩ to 1 MΩ, and the current FRFs also demonstrate monotonic dynamic behavior, but the trend is opposite to the voltage FRFs. In contrast to the voltage and current FRFs, the output power FRFs do not show a monotonic trend, exhibiting the maximum value of 150 μW/g 2 at 75.1 Hz without the proof mass. The output power increases to 392 μW/g 2 at 62.2 Hz when the proof mass is attached. This preliminary study indicates that EAPap is promising for energy harvesting transducers under vibration environment.