Improvement of the Tribological Properties of Alumina Coatings by Zirconia Addition

• Published in: Coatings (Basel) Vol. 11; no. 8; p. 991
• Main Authors: Mathew, Jacob Shiby, Marcinauskas, Liutauras, Kalin, Mitjan, Kėželis, Romualdas, Kavaliauskas, Žydrūnas, Gecevičius, Giedrius, Čapas, Vytautas
• Format: Journal Article
• Language: English
• Published: Basel MDPI AG 01.08.2021
• Subjects: Air flow; Alumina; Aluminum oxide; Arc spraying; Coatings; Coefficient of friction; Corrosion; Dielectric properties; Friction; Gases; Hydrogen; Mechanical properties; Morphology; Phase composition; Plasma; Plasma spraying; Raw materials; Sprayed coatings; Stainless steels; Steel; Surface roughness; Transitional aluminas; Tribology; Wear rate; Zirconium dioxide; United States > US; Japan
• ISSN: 2079-6412; 2079-6412
• DOI: 10.3390/coatings11080991

Al2O3 and Al2O3-ZrO2 coatings were deposited on stainless steel using atmospheric plasma spraying. The influence of arc current and zirconia addition on the surface morphology of the coating, phase composition and tribological properties under dry sliding conditions were investigated. The addition of zirconia reduced the surface roughness of the coatings. The X-ray diffraction measurements indicated that the Al2O3 coatings were composed of β-Al2O3, α-Al2O3, and γ-Al2O3 phases. The addition of zirconia led to the formation of tetragonal and monoclinic phases of zirconia in the as-sprayed coatings. The friction coefficients of Al2O3 and Al2O3-ZrO2 coatings were similar and varied in the range of 0.72–0.75. The specific wear rates of the as-sprayed coatings were reduced with the increase of arc current. It was obtained that the wear rates of the Al2O3-ZrO2 coatings were at least three times lower compared to Al2O3 coatings.